answersLogoWhite

0


Best Answer

Unfortunatly there isn't one. I am actually looking for an aftermarket oil level sensor to install in my 1994 silverado.

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the location of the low oil level sensor for a 1994 silverado?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the vehicle speed sensor located on a 1994 Chevy silverado truck?

The vehicle speed sensor, on your 1994 Chevrolet Silverado pickup truck, is located on the back of the transmission. The speed sensor is labeled as such.


Does a Chevy 1994 silverado 1500 have an IAT sensor?

NO it does not.


Where is the MAF sensor on a 1994 Chevy silverado 5.7 liter?

A MAF sensor was not used in 1994. It don't have one.


What is an AFM sensor on a 1994 Chevy Silverado?

The 94 model does not have a MASS AIR FLOW SENSOR.


Will a knock sensor stop a transmission from working properly in a 1994 Chevy Silverado?

NO.


Where is the IAT sensor on a 1994 Chevy Silverado with a 5.7L engine?

That year DID NOT USE THEM.


1994 Chevy Silverado knock valve sensor location?

If your refering to the engine knock sensor, it is moounted in the side of the cylinder head and has a single wire connector. try not to damage it when removing, it is a piezo electric device and is vulnerable to impact.


Where is the knock sensor located on a 2003 4.3L V6 silverado?

I don't think Chevy changed the location of the knock sensor. On my 1994 4.3 its on the left hand (drivers side). There are 2 sensors there, one of them is the temp gauge sending unit and the other is the knock sensor.


Where is the coolant temperature sensor on a 1994 Chevy Silverado?

It is screewed into the intake manifold right beside the thermostat housing.


Crank sensor location on 1994 Nissan pickup?

inside motor


Where is the Location of the knock sensor on a 1994 jeep wrangler?

Doesn't have one.


Where is the O2 sensor location on 1994 GMC truck?

The sensor is located by the catalytic cnverter on the inlet side.