answersLogoWhite

0

Where is the fuel pump inertia circuit breaker located on a 2008 Toyota Corolla

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you reset the maint reqd light on 2008 Corolla?

To reset the "Maint Reqd" light on a 2008 Toyota Corolla, turn the ignition to the "ON" position without starting the engine. Press the gas pedal three times within five seconds. After doing this, the light should turn off, indicating that the maintenance reminder has been reset. If it doesn't reset, repeat the steps to ensure they are done correctly.


How do you reset the Maint required light on a 2008 Chevy Colorado?

read your owners manual


What is the set button on the dash of a 2008 Toyota Corolla S for?

is to reset your tire light in panel... Look this video: https://www.youtube.com/watch?v=sh0A5QCgwAU


How do you turn off a maint reqd light and the exclamation point light off of a Toyota matrix 2008?

Hold down the "trip reset" button with the ignition off and keep it pressed while you turn the ignition on


How do you reset maintenance reminder light 2008 Toyota Corolla?

How do you reset maintenance reminder light on 2008 Toyota corolla? For what it is worth: To reset the Maintenance Required light on my 2007 Toyota Corolla: 1) Set your trip meter to the odometer setting (in other words, not Trip A or Trip B) 2) Hold down trip meter reset button and turn ignition to off. 3) While holding down the trip meter reset button now turn the ignition to on. 4) Keep holding down button until Maintenance Required light shuts off. Note: One some other Toyota models you hold down the Trip A meter rather than the odometer. Hope this works for you.


Where is the 2008 PT Cruiser fuel reset button?

Chrysler does not use inertia/reset switches.


Reset 2008 Toyota Corolla tire pressure light?

To reset the pressure light, first inflate the tires to the proper cold pressure (30-32 lbs, or as the sticker says on the door frame when you open the car door), and then hold the button in for five seconds on the pressure light.


Where is 2008 dodge caliber fuel pump reset button?

Dodge does not use inertia/reset switches.


Where is the fuel pump reset switch located in the 2008 Honda crv?

There is no such reset button on your Honda CRV.


Where is reset button on 2008 Cadillac DTS?

The reset button for the 2008 Cadillac DTS is typically located in the trunk, near the spare tire compartment. It may be labeled as the "trunk release" or "reset" button. If you're looking to reset the tire pressure monitoring system (TPMS), you can usually find the reset button near the driver's side dashboard or under the steering wheel. Always refer to the owner's manual for specific locations and instructions.


How do you reset trip odometer in 2008 c300?

To reset the trip odometer in a 2008 Mercedes-Benz C300, press the "Trip" button located on the instrument cluster until the trip odometer you want to reset is displayed. Then, press and hold the same "Trip" button for a few seconds until the reading resets to zero. Make sure to release the button once the reset is complete.


How do you reset a oil light on a 2008 Nissan Altima?

To reset "Maintenance Notice" on the display, turn the ignition key to ON, with engine off. Select the "Maintenance Schedule' key by using the button to right or left. Using the button select the "Reset" key and push the "Enter" button.