Want this question answered?
It uses a manifold absolute pressure sensor.It uses a manifold absolute pressure sensor.
This is the Manifold Absolute Pressure sensor. It is located on the top of the motor between the fire wall and the intake manifold case.
It's the MAP sensor...Manifold Absolute Pressure.
The manifold absolute pressure (MAP) sensor, is located on or around the intake manifold, and provides constant information concerning the amount of pressure inside the intake manifold.
It does not use a MAF. It has a MAP sensor (manifold absolute pressure) on the front of the intake manifold.
The Manifold Absolute Pressure (MAP) sensor is located near the throttle body on the intake manifold.
a map sensor is a manifold absolute pressure sensor.
the map sensor is located on the air intake manifold on the left side under the throttle position sensor on the 2.2 4 cyl. motor.
The Manifold absolute pressure sensor on a fiero V6 is mounted on the passenger side manifold right beside the thermostat assembly/water outlet
The manifold absolute pressure (MAP) sensor is an important component to your 1994 General Motors Blazer/Jimmy's EFI system. This pressure sensor is located provisioned into the intake manifold assembly.
The MAP sensor is located on the firewall of the engine compartment, right by the stamped VIN number on the firewall..
The Manifold Absolute Pressure sensor is located to the rear of the engine well, slightly on the left hand side. It is on top of the intake manifold.