answersLogoWhite

0

Mass air flow sensors are always located inline between the aif filter and plenum intake.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How do you replace a thermostat on a 94 grand am 2.3 liter?

information on how to change the themostat on a 94 Pontiac Grand am SE 2.3 liter


Where is the camshaft sensor on a 1996 4 liter grand Cherokee?

The cam sensor is inside the distributor under the rotor.


Where is bank 1 sensor 2 oxygen sensor located on 2000 Dodge Grand Caravan 3.8 liter?

It is the sensor in the outlet of the catalytic converter.


How do you replace the crankshaft sensor in a 1985 Oldsmobile Calais Supreme LN7 3.0 liter engine?

changing the crankshaft sensor


How do you replace crankshaft sensor on a VW jetta 2.5l 2006?

where is the crankshaft position sensor on 2.5 liter vw jetta


Where is the location of the crankshaft position sensor on a Pontiac grand am 3.6 liter?

Some place in the world i think


Check engine light on on 98 jeep grand Cherokee 4.0 liter IS ON .I REPLACED CONVERTER AND IS STILL ON.?

Run a computer diagnostic test to figure out WHY it's on. Why replace a converter when the problem could be an oxygen sensor?


Where is the location of the Camshaft Sensor on a 1995 5.2 liter V8 in Jeep Grand Cherokee Orvis Edition?

On my 97 jeep grand Cherokee, with the 5.2 liter v8, its located in the distributor, under cap & rotor.


Jeep Grand Cherokee with the 4.7 liter engine and it consistently revs to around 2200 rpm on start up regardless of engine temperature can it be adjusted to not rev so high?

Replace the TPS (Throttle Position Sensor).


Where is the location of the crankshaft position sensor on a Pontiac grand am 2.4 liter and how to install it?

right above the oil filter


What is the knocking noise in engine 3.8 liter Pontiac grand prix?

Replace the Harmonic balancer


Where is the crankshaft sensor on a 1995 Pontiac grand am 3.1?

The 1995 Pontiac Grand Am 3.1 liter engine crank shaft sensor is located inside of the rear engine cover. You will need to remove the rear engine cover in order to access the crankshaft sensor.