Mounted near or on the firewall driver's side.
In a Chevy Cavalier, you put the brake fluid in the brake fluid reservoir located atop the master cylinder. You can find this under the hood, on the drivers side, near the back firewall on top.
I found the answers to a lot of my questions about my 99 Cavalier by buying a Chilton's manual for the car.
In the master break cylinder
Where is the stater located on a Chevy Cavalier located?
It may be that your clutch master cylinder is bad, or more than likely one of the internal components within the cylinder, have the clutch master cylinder checked.
They should be on the side of the cylinder head. they will have plug wires ging to them.
under the master cylinder.
Need to know how to assemble 95 Chevy clutch master cylinder?
It should be very close to the clutch bellhousing itself. Follow the hydraulic line from the clutch master cylinder down. I hope this helps you. it's actually inside the tranny between the motor and tranny good luck .....chevy boy
Replace the master cylinder.
there is none its controled by the tps sensor located on the pleteum
How do you change a Master Cylinder and hydraulic clutch line for a 1998 Chevy S10?
Where is radiator temperature sensor located on a 1997 2.4L Chevy cavalier
under driver's floor board. there is a hole in the floor to fill it.
i have a 1997 chevy cavalier the wipers and radio work when turn the key swich back
The Front-Passenger-Side Cylinder
The PCV valve on a 2002 Chevy Cavalier is located on the back of the valve cover. It is a plug in type.
This is a far reaching question that needs more clarification. There are cylinders where the pistons are located. If you have a clutch then you have a clutch master and slave cylinder. On the brakes you have a master cylinder and wheel cylinders. And the beat goes on. You need to distinguish as to which cylinder you are referring.
The clutch bleed valve on a 2.2 liter Chevy Ecotec engine is located on the slave cylinder. To find the slave cylinder remove the battery, as it is mounted underneath the battery tray.
The clutch master cylinder on a Chevy S10 is replaced by disconnecting the metal lines, unscrewing the retaining bolts, and removing it from the housing. A new master cylinder can then be put into place and reattached.
Most of the time it is because of a bad slave cylinder that does not hold pressre or is leaking. They use brake fluid and to check them look at the CLUTCH MASTER CYLINDER near the firewall.
how do you replace ignition switch on a 1992 Chevy cavalier 2.2 4 cylinder
The 2004 Chevy Cavalier didn't come with a carburetor, they were all fuel injected.