Follow the positive cable wire from the battery and it will end up plugged right into the safety switch.
How to change door speakers on a 1997 mercury tracer wagon
Begin by removing the retaining ring at the top of your 1996 Mercury Tracer ignition switch. The ignition lock cylinder will slide out. Remove the wiring harness from the end of the cylinder. Reverse the process to install your new ignition lock cylinder.
100,000 miles
Mercury Tracer was created in 1987.
Buy the Service Manual and follow the instructions.
Seat belts are never repaired, replaced only.
on the 1.6l it does not have pushrods . it has an adjuster on the end of the rocker arm.
It should be located on the evaporator case.
Drain the Mercury Tracer radiator into a pan. Loosen the clamps at the ends of the radiator hose. Wiggle the hose to free the ends. Slide the hose off and replace it. Tighten the clamps an refill the radiator. Dispose of the old antifreeze as it is toxic to animals.
Remove the belt from your Mercury alternator. Remove the wiring harness from the alternator. Remove the retaining bolts. Reverse the process to install your new alternator.
On your 1991 MERCURY TRACER, the THERMOSTAT is: UNDER HOOD, DRIVER SIDE, UPPER ENGINE AREA, ENGINE END OF UPPER RADIATOR HOSE, MOUNTED IN COOLANT OUTLET HOUSING.
need timing marks for 97 mercury tracer