I don't know the specific location but it is screwed into the transmission somewhere.
The neutral safety switch is on the side of the transmission. It screws into the side and has a small three wire plug.
go to www.naxja.org or www.jeepforum.com and do a search for "neutral safety switch. There will be links to jeep owners sites that have detailed instructions
Safety neutral switch
On your 1992 FORD TRUCK AEROSTAR 4WD, the NEUTRAL SAFETY SWITCH is: UNDER VEHICLE, CENTER, BELOW SEATING AREA, MOUNTED ON DRIVER SIDE OF TRANSMISSION info obtained from www.autozone.com
The neuteral safety switch prevents the car from being able to start in any gear except park and neuteral.
Just jump it or splice the wires together once you find the switch. A wiring diagram will provide location.
How do you replace the ignition swith opn a 1992 Pontiac Bonneville se
it is located under hood in relay and fuse holder. right by driver front fender
The lower one (sits sideways) is the neutral safety/reverse light switch. The upper one (points down) is for the overdrive and torque converter clutch solenoids.The lower one (sits sideways) is the neutral safety/reverse light switch. The upper one (points down) is for the overdrive and torque converter clutch solenoids.
on the top of the steering column, close to the floor is the neutral safety switch. it is a plastic (usually white) piece with wires plugged into it. a screwdriver will remove two screws one on eash side. If your engine starts only in park or neutral then the neutral safety switch is ok. if your engine starts in any other gear then it needs to be replaced. hope this helps. EXCUSE ME FOR BUDDING IN BUT YOUR ARE WRONG. THE NEUTRAL SAFETY SWITCH IS LOCATED AT THE TRANSMISSION CASE ON THE DRIVERS SIDE AS IT IS ON ALL FORD PRODUCTS WITH THE AOD STYLE TRANSMISSION WHICH IS THE ONLY TRANSMISSION THE THIS CAR CAME WITH THRU 1992 DAVE FROM LEE MYLES TRANSMISSIONS ROSLYN HEIGHTS NY 516-484-0010
I am about to find and change one on a 1992, I think the process should be similar.....I will post the results ASAP..If I am successful!!!!!!!!!!!!!!
GM does not equip their vehicles with a fuel pump inertia switch.