Hey There: Before this question can be answered,,,,you must provide alittle more information,,,such as,,,what size is the motor,,,a 2.6,,,3.2,,,3.5,,,this is critical,,,if i am to give you an accurate answer.
1-3-4-2
1-3-4-2 Distributor rotates counterclockwise.
On a V-6 shaped block, bank 1 is passenger side cylinders 1-3-5. Bank 2 is the driver's cylinders 2-4-6. Cylinder 1 is passenger side closest to the radiator. Same with cylinder 2 only on the drivers side. This makes cylinders 5 and 6 furthest back on the firewall. From the driver's seat you are looking out over bank 2.
The coil numbering for the 1994 Isuzu Trooper typically follows a specific sequence related to the ignition system. Generally, the cylinder numbering starts from the front of the engine, with cylinder 1 being on the driver's side, and proceeds to the rear. For the ignition coils, they are usually labeled according to their corresponding cylinder positions, with coil 1 servicing cylinder 1, coil 2 for cylinder 2, and so on. It's important to refer to the vehicle's service manual for precise details and diagrams specific to your model.
Bank 1 is the side that cylinder 1 is on, sensor 1 is downstream and sensor 2 is upstream
The price of a 1988 Isuzu Trooper 2 can vary widely based on its condition, location, mileage, and any modifications. Generally, you might find prices ranging from $1,500 to $5,000. However, well-maintained or restored models can command higher prices in certain markets. For the most accurate valuation, it's best to check local listings and classic car sales.
The firing order for a 99 Isuzu Trooper 3.5l is 1, 2, 3, 4, 5, 6. The number one cylinder is on the left side in the front as you are facing the car.
The firing order for a 1991 Isuzu Trooper 2.8 liter 6-cylinder is 1, 2, 3, 4, 5, 6. The spark plug gap is .045 (in thousandths of an inch).
firewall 3 - 6 2 - 5 1 - 4 front
On the 1998 Toyota Sienna, cylinder number 2 is located on the passenger side of the engine, specifically in the second position from the front of the vehicle. The Sienna is equipped with a 3.0-liter V6 engine, and the cylinders are numbered from front to back, starting with cylinder 1 on the front driver's side. Therefore, cylinder 2 is adjacent to cylinder 1 and is part of the engine's firing order.
i have a 1998 trooper and i had to get a robe #2 screw driver and take off the outer housing of the socket and replace bulb and replace outer housing, be sure you put on gasketcorrectly or water will get into it.
#1 cylinder is at the front of the engine ( 1, 2 , 3 , 4 front to rear )