Ford Bronco

Where is the number 1 piston on a 1987 ford bronco?


Top Answer
User Avatar
Wiki User
2005-09-17 22:26:55
2005-09-17 22:26:55

the cylinder or spark plug that sits farthest foword.gmjim

User Avatar

Related Questions

firewall 4 - 8 3 - 7 2 - 6 1 - 5 front of Ford Bronco ( V8 )

4 banger is 1234 number 1 is closes to front of truck

should be passengerside front,(right behind alt.

The Eddie Bauer was an option ordered from Ford. It was the top of the line Ford Bronco from 1987 to 1996

Ford V8 engine : firewall 4 - 8 3 - 7 2 - 6 1 - 5 front

firewall 4 - 8 3 - 7 2 - 6 1 - 5 front

yes ,but the interior door panels are different

Were are all the vin numbers on a 1973 ford bronco

if, you have the 2.9 it is 10 btdc

Full back soft tops for the Ford Bronco can be found on

To repair the head gasket on a 1987 Ford Bronco, the head and the old gasket must be removed. Purchase a new head gasket and carefully install it according to manufacturer specifications.

yes,if both are 2.9 motors,both are 4wd, and you are talking about the bronco2,not the full size bronco

yes they will interchange . you should have mo major problems switching them.

If it is the same as the ( 1996 ) Ford Bronco : ( Relay # 2 is the fuel pump relay )

96 EB Bronco 5.8L EFI what is the standard fuel pressure

Probably not because the Ford Bronco and Ford Bronco 2 were not very good by their motor.

No there isn't. The Ford Bronco and Ford Bronco II have not sold very well and The Ford Motor Company is not interested on making a Ford Bronco III because of this situation.

According to one of Fords websites : For a 1987 Ford Bronco , 4.9 liter / 300 cubic inch straight six cylinder : ( the spark plugs are gapped at .044 inch )

Ford Bronco was created in 1966.

All 1978 and later Ford Broncos have interchangeable tailgates. I found this out grom the junk yard when I was looking for a replacement tailgate for my 1978 Bronco.

i wont swear by it but i think the 2.9 puts out 140 hp

I have a 1987 ford bronco and I changed the heater core in about 15 minutes. All you have to do is remove glove box and there is a panel with a few screws around it. and there you go.

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.