because it is
On My 2001 Chrysler T & C it is located on top center in the back of the engine
Screwed into the exhaust manifold on the back of the engine.
where is the crankshaft sersor on a 2001 Chrysler sebring located
It is behind the front bumper, in front of the radiator.
There are two in the exhaust, behind the engine.
MAP sensor if I recall
It is tucked behind the engine mount bracket on the passenger side.
The engine coolant temperature sensor and coolant temperature sensor are the same.
There are two in the exhaust system on the rear of the engine.
It's part of the MAP sensor, mounts on left side of intake.
Left lower on engine block.
The throttle position sensor is the three wire sensor on the throttle body opposite of where the cables attach.
The circuit is the two wires that run from the TCM to the output speed sensor.
The output speed sensor is on the front of the transmission case, to the far driver side.
It is inside the tank, on the side of the fuel pump module.
I believe it is on the transmission bellhousing, near the firewall. It is under the pipe that connects the front and rear exhaust manifolds. on the 3.8l
The speed signal on a 2001 Chrysler Town and Country comes from the transmission output speed sensor. That part is usually only about $30.
The output speed sensor is on the front of the transmission case. It is the two wire sensor on the driver side.
On a 2001 Chrysler Town and Country, the fuse for the speedometer is located in the fuse panel. The panel can be found under the hood next to the battery.
The 2001 Chrysler Town-AND-Country has a V6 engine.
The 2001 Chrysler Town-AND-Country has 12 valves.
A 2001 Chrysler Town and Country uses 5w30.
The 2001 Chrysler Town-AND-Country has a 4-speed automatic.