Want this question answered?
Just did it on my 2007. First make sure the trip odometer is set to Trip A. While holding in the odometer reset button, push to engine start button twice (but not with your foot on the brake pedal). After continuing to hold the trip OD button for about 4-5 seconds you'll see the Oil Maintenance Req'd message disappear. Sounds simple.
The ODO trip button is a small black button on the lower left side of the display shield.
The Trip Odometer is normally reset by pushing and holding the reset button in. The odometer can not be reset.
With the car off you will need to:1. (without putting your foot on the brake) hit the start button twice.. Then2. Hit the odometer stem to make it go to trip a (where the odometer reads.)3. Turn the car back off and then hold in the odo pegand4. Hit the start button twice again ( without your foot on the brake) and it will reset.
Where is trip odometer reset button on vauxhall insignia
You can not reset the odometer. The trip meter can be reset by holding down the button.
Press the RESET button.
1. Make sure your trip odometer is on Trip A. 2. With the car turned off, press and hold the "Reset" button for the trip odo. 3. Foot off the brake, press the start button twice while holding the reset button and wait for it to reset.
With the ignition off, press and hold in the reset button for the trip odometer, then turn the ignition on. Hold the trip odometer reset button until the service reminder indicator starts flashing (about 10 seconds). Release the reset button for the trip odometer within 4 seconds.
For Maintenance Required warning light on 2008+ Highlander Hybrid: Start from car in OFF mode. Keep foot off brake pedal, press START/STOP botton twice, reset odometer A & B. While in odometer A, press & hold odometer reset button and simultaneously press START/STOP button to turn off. Press & hold odometer reset button and simultaneously press START/STOP button twice. Wait for the indicator bar to complete reset cycle and then release odometer reset button.
Sit in the driver's seat. Put your seat belt on. With the key in the off position, press and hold in the odometer reset button. Turn the key one click (keep holding the odometer reset button in). Very shortly afterwards you will get a "RESET" (or similar) display. Release the odometer reset button. The display "RESET" will blink. While blinking press the odometer reset button again. That should do it.
The reset button is the black plastic stick next to the odometer. You hold it down for at least 2 seconds. Now if you want to reset the trip odometer that is on the selector switch lower right corner on the instrument panel.