answersLogoWhite

0


Best Answer

Under the car on drivers side, about even with rear of front wheel well

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the oil filter on a 2008 Mazda miata?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the oil filter on your 2006 Mazda miata?

Just underneath of the engine.


What does Proline ppl14612 oil filter fit?

It fits a 2002 Mazda Miata; 4 cylinder


What is the oil capacity for a 1999 Mazda Miata?

A 1999 Mazda Miata requires 4.0 quarts of oil.


How do you change an oil pan gasket on 1995 Mazda?

Is it difficult to remove an oil pan for a 1995 mazda miata?


What is the oil capacity for a 1996 Mazda miata?

4 quarts


Mazda 121 oil filter?

what oil filter does mazda 121 uses


What type and Weight of Oil for a Sportage?

5W30. The engine in the Sportage is from Mazda, and based on the same engine used in the Miata. Use a full synthetic 5W30 with a good oil filter. There isn't as much Sportage info out there as there is Miata, so look that up if you need more info.


Where is the oil filter on a 2001 Mazda miata 1.8L engine?

It is on the passenger side of the engine under the intake manifold. When I first located it, I wasn't sure it was possible to get a oil filter wrench on it, but you can with your left hand leaning over the passenger side fender.


How many quarts of oil does a 2000 Mazda Miata TAKE?

3.8 to 4 quarts of engine oil.


Where is the drain tube for the air conditioning in a Mazda miata?

The Mazda Miata air conditioning drain to can be found on the bottom of the air conditioner compressor. The drain to runs to the bottom of the oil pan.


How do you fix a Mazda miata engine that taps after starting?

Miata's tend to tick a little.You can try 5-30 oil at your next oil change but it's unusual for a Miata not to tick a little at start up.


Where is the oil filter on a 92 Mazda miata?

Look right below the intake manifold. It should be hiding right below it. It is hard to get to, but it can be done. Get a special tool that fits on the Miatas oil filter and uses a ratchet to turn it. Its basicly like a big socket....just made to fit an oil filter. This makes the job much much easyier. Greddy makes a oil filter relocation kit for the Miata, I hear they make it much easyier...but I still do mine the old way.