under the front of the car on the driver side .
The total amount of oil it takes to fill the canister on a 2001 Mitsubishi Galant is 4.5 quarts. This oil should be 5W20 or 10W30.
It's on top of the transmission. Looks similar to oil filter.
Answerit's next to the oil filter
It is located between the engine and firewall.
5w-30 or 10w-30 if higer miled
Same as any other car. Eliminate the Mitsubishi Galant and this has probably already been answered.
The oil pump on a 1999 Mitsubishi Galant ES, is located behind the crankshaft an timing pulleys. You'll have to dismount the oil pan, all the timing belt system and all the pulleys nearby to get to it.
Engine Oil - use with API certification Transmission Oil - Used OEM Mitsubishi Transmission Oil Only.
The suggested motor oil for a 1997 Mitsubishi Galant is a light 5W30 conventional oil. Older engines made need a little heavier oil to prevent leaking.
The oil filter is located in the rear of the engine compartment; close to the firewall. If underneath the vehicle; you will see it exposed ranging from white, orange, black, or blue.
all drain plugs are located at the lowest point of the oil pan.
17mm wrench, oil pan, oil and jack stands or wheel ramps.
i personally have never heard of an engine block plug.could you be talking about an oil plug located on the oil pan or there is another plug on the radiator.
You can use API GL-4, SAE 75W90 semi synthetic for your Galant. There are standard types of oil used in these types of cars.
on the oil pan. hope this helps.
It takes a 15mm wrench.
Oil - rear or side of oil pan Radiator - bottom or rear of radiator
Can you? Yes. Should you? NO! Use exactly what Mitsubishi recommends and that is not 15w40.
1 billion dollars
2003 Mitsubishi Galant 2.4L four cyllinder or 3.0L V6 sold in Canada and US comes with 5W30 engine oil from the factory. Full synthetic is strongly recommended if car is used for city driving or prolonged idling.
PCV valve is a gauge for gases to pass through to engine. It is located close to oil fuel tank center engine, the gasket cap must be removed to access it.