0
The oil pan is located right under the engine.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Do you have to take off oil pan for 2003 jeep Cherokee when changing oil?
No, the oil pan has a plug, usually a 9/16" one, that is located on the lowest part of the oil pan. That's where you drain the oil from. There should never be a need to take off your oil pan unless you have much more serious issues than just an oil change.
Where is the oil drain plug located on a 2006 Harley Deuce?
The oil drain plug is located on the bottom of the oil pan. The oil drain plug will be near the front of the oil pan and can be removed with a 9/16 ratchet.
How many quarts of oil are in a Ford F-350 7.3 Diesel?
According to my owners manual for a 1994 F350 Turbo Diesel there are 10 quarts of oil including 1 quart for filter replacement ( 1-in the filter--9-in the pan)
Oil pan bolts torque specs on b18a1?
9 ft-lbs
What is the Oil drain plug torque Ford e450 6.9 liter gas v10?
According to Ford Documentation 2003 E-Series, 9/2002, Page 303-01C-3, Engine 6.8L, the Oil Pan Drain Plug torque is 12 Nm and 10 lb-ft.
Where is oil filter of Saab 9-5?
On a 2002 Saab 9-5 it is by the oil pan.. Look under the front of the car and you should see it.
What is the torque specs for 1995 Neon oil pan bolts?
9 ft lb
How do you repair oil leak in oil pan on 1996 ford escort 1.9 liter?
How to replace the oil pan seal: 1. Jack up the front end and put it on stands. 2. Drain the engine oil. 3. Remove the catalytic converter. 4. Remove both bolts that hold the oil pan to the transmission. 5. Unbolt the oil pan and lower it from the engine. 6. Bump it with a rubber hammer if it is stuck. 7. Don't pry it off because it will damage the mating suraces of the pan and gasket. 8. Remove the gasket from the pan. 9. Install a new oil pan gasket in the pan. 10 Make sure the tabs of the gasket are pressed all the way in on the channels of the pan. 11. Apply a 1/8 inch bead of silicone sealer to the corners of the block and to the points where the oil pump meets the crankshaft. 12. Install the oil pan bolts and the oil pan to transmission bolts. Make sure you have the 2 spacers between the pan and the transmission. 13. Starting in the middle criss cross back forth towards the end of the pan to torque down the bolts. Torque the bolts to 15-22 ft./lbs.
How do you change radiator in 1999 Saab 9-5?
To change oil in Saab 9-3 the hood will need to be opened and then the oil drained by using the drain pan. With the oil plug removed, the oil can now be changed.
Where is the sump on Saab 9 5?
The SAAB will have an oil sump, specifically the oil pan collection for the engine oil and the fuel sump, the collection area for the fuel pump to pull from.
How do you remove the oil pan on a 1997 Acura CL?
Hello, The following is a procedure on removing and installing the oil pan on a 1997 Acura CL 3.0: 1. Raise and safely support the vehicle 2. Drain the engine oil into a suitable container. 3. Remove the exhaust pipe if necessary. 4. Unfasten the oil pan mounting bolts, then remove the oil pan. 5. Clean the sealing surface on the engine and oil pan flange. 6. Apply a bead of sealant to the oil pan flange and install the oil pan. Tighten the bolts to 104 inch lbs. (12 Nm) 7. If removed, install the exhaust pipe. 8. Add the correct amount of engine oil to the crankcase. 9. Start the engine and check for leaks. I hope this helps you out!
Where is the oil drain plug on your 2006 volkswagen jetta?
The 2006 VW Jetta oil drain plug will be on the bottom of the oil pan. You can remove the drain plug with a 9/16 wrench.
