Oil Pressure Sender and Switch
Ford Ranger/Explorer/Mountaineer 1991-1999 Check Related Links below.
Where is the oil pressure sending unit on a 1995 F150 truck with a 302 motor at
It is located in the front of the motor just above the starter.
The Oil Pressure Switch (Oil Sending Unit) is located on the rear of the motor towards the top. The crank sensor is located next to it if that helps any.
The oil pressure sending unit on a 302 ford is located on the block of the engine. It screws into the block and the sending unit goes on the end. The oil pressure sending unit on a 302 Ford is slightly above and to the left of the oil filter. I find it is easier to replace with the oil filter out.
At the rear of the engine just behind the distributor
It is located under the motor right next to the oil filter. I just changed mine today.
It is on the back of the engine, just to the passenger side of the distributor.
The oil pressure sending unit is on the back of the block just above the bell housing. The unit screws in.
What size motor?
The oil pressure sending unit is located on top of the motor beside the base of the distributor. You will need a special socket from your parts store to remove/install the sending unit without harming the new one. The socket is not expensive and does fit sending units for other cars.
uhmmmmm there is no such thing a a k1500 with a 318 cubic inch engine.
Directly above oil pressure sending unit. Hard to reach, motor mount obstructs access.