above the filter
Screwed into the engine block very near the oil filter.
You need to replace the governer pressure sensor, and the governer pressure solenoid. They are both located on the passenger side of the valve body, inside the transmission.
It's located on the intake manifold itself.
Yes. That is most likely a sensor malfunction and will do no harm. Zero pressure is when you worry.
R H REAR OF THE ENGINE
top of the fuel tank
the sensor is located next to the oil filter on the oil filter casting.
It is also known as a Pickup Coil that is located under the rotor inside the Distributor cap.
Left lower on engine block.
Make sure you are looking for the THE OIL LEVEL SENSOR and not the oil pressure switch. Oil level sensor should still be located on the oil Pan.
Under hood, center, upper engine area, mounted in driver side of water outlet
I cannot say for sure about jeeps after 2001 because I dont have much experience with these vehicles but pre 2001 all jeep crank sensors are located on the top of the transmission bell housing you can access the sensor from underneath the vehicle