answersLogoWhite

0


Best Answer
Copy

The 1983 Cadillac Deville oil pressure sensor can be found on the side of the engine. The oil pressure sensor will be on the left-hand side of the engine.

User Avatar

Wiki User

โˆ™ 2014-09-18 00:23:16
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +5 pts
Q: Where is the oil pressure sensor on a 1983 Cadillac DeVille 4.1?
Write your answer...
Submit

Related Questions

How do you installed a rear window motor in 1983 Deville convetible Cadillac?

Cadillac did not produce a DEVILLE convertible in 1983. ELDORAO yes. If it is a 1983 DEVILLE convertible, its custom made. To start remove the lower rear seat cushion and inside trim. Sorry I cant help further not knowing its customizing technique.


What is the firing order for a 1983 Cadillac DeVille?

the firing order on 83 deville with a 4100 v8 motor is as follows, 18436572. this firing order should also be in raised numbers on your intake manifold.


If a 1983 Cadillac deville power locks don't work is it a fuse problem?

it could be ...check fuse 15 it controls ur power locks


When was Brooke DeVille born?

Brooke DeVille was born on May 27, 1983, in Monroe, Louisiana, USA.


Where is the fuel pump relay located on a 1983 Cadillac Deville?

If it is carbureted and probably a V8 there is no fuel pump relay. the fuel pump is mechanicly driven and it is located on the front of the block on the passenger side.


How much does a 1989 Cadillac fleetwood weigh?

how much a 1983 cadillac fleetwood geigh


The fuel pump on a 1983 Cadillac?

in the tank.


What transmission is in your 1983 th4100 Cadillac?

th2004R


Does a 1983 Chevy Celebrity have a crankshaft sensor?

No, the 1983 model does not have a crankshaft position sensor. Only distributorless engine needs a crankshaft position sensor.


Why does the fuel gauge always remain on full in a 1983 Cadillac DeVille coupe?

eather the gage is broke, or the floats stuck, try hitting the side of the gas tank with a hammer,lightly. Plus, have you drivin the car in a while? the needle could simply be stuck.


What motor will the transmission in the 1983 Cadillac with a 4.1L?

This question makes no sense


Where can you get a diagram of the fuse box in a 1983 Cadillac Seville?

The Owner's Manual


Where is the fuel sensor for a 1983 Datsun 280zx?

inside the tank


How to replace crankshaft position sensor on a 1983 mercury grand marquis 302 v8 engine?

1983 doesnt have a crankshaft position sensor. you have an ignition module located on the side of the distributor.


Where is the fuel pump switch located on a 1983 cadillac devile?

It is not equipped with an inertia switch.


Where is the water temp sensor located on 1983 ford bronco six cylinder?

The temp sensor is located on the intake manifold


Where is the fuel pump located on a 1983 Cadillac Eldorado?

I HAVE A 1983 ELDORADO IT'S IN THE FEUL TANK. IT BETTER TO LET THE DEALER CHANGE IT IF YOU DO IT YOUSELF YOU HAVE TO BE REAL CAREFUL.


Where is the oxygen sensor on a 1983 Camaro?

On the driverside exaust manifold under the hood


How many pounds of torque on rod bearings 1983 cadillac 4.1 V8?

22 ft lbs


What is the pressure on a at modulator for th 400 tranny on a 1983 Chevy 6.2l k20 diesel?

The 400 tranny on a 1983 Chevy 6.2L K20 diesel have very high pressure.


Need diagram of waterneck and sensor fittings for Chevy 305 1983?

1983 Chevy 305 diagram, waterneck, thermostat housing and fittings


How do you remove door panels on 1983 Cadillac el dorado?

I have a 1983 Cadillac El Dorado and the window on passenger side doesn't work. I checked power to switch (ok) and checked switch and it is also ok. I assume that the wiring is loose or motor is bad. How do I remove panel on door


Where do you pour transmission fluid 1983 cadillac?

you use a funnel to put it down the same tube that the dipstick came out of.


When was Pressure Cooker - video game - created?

Pressure Cooker - video game - was created in 1983.


Where is the starter solenoid on a 1983 Cadillac Eldorado?

Should be on the side of the starter. Small cylinder on the side. The positive cable connects to it.