How do you reset the low coolant light on a 2000 Oldsmobile Intrigue?
There is no reset button or wsitch Check overflow tank under the hood and if low add coolant. If the coolant level is ok it may be the sensor on the bottom of tank is dirty with sluge. This sensor is the one which gives the low coolant indication. Remove tank and flush it out several times with clean water and re-install, refill tank with coolant to proper level.AnswerIt should go off when you fill up the coolant. If not, you may have a bad sensor, or possibly need to have it reset. Autozone can reset the diagnostic controller (DBM-II) for free while you wait. Hopefully there is no bigger problem that that. Answera. add more coolant b. if the light remains on, check the low coolant sensor and the connector that goes to it. It's usually on the side of the radiator or the bottom of the overflow tank.AnswerNo, there isn't a "reset" function for the low coolant level. The sensor (acts as a switch) will shut off the low coolant level warning light on the instrument cluster once you've filled up the coolant reservoir to the proper level. The coolant level sensor for this vehicle is located in the coolant reservoir (NOT THE RADIATOR). Keep in mind however, these sensors do go bad. So, just swap out the sensor? Not on this vehicle; the sensor isn't sold a a separate unit (darn it). You must purchase a new coolant reservoir, which includes a built in sensor. Multiple internet suppliers sell these reservoirs for $70 (including shipping).A correction to someone else's post: no, a diagnostic scanner (OBD-II) will not "reset" this warning light. So don't impose on Auto Zone on this one.
