0
Where is the oil sending unit located on a 2002 Chevy cavalier?
Wiki User
∙ 11y ago
on the front bottom part of the motor above the starter
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
How do you install a starter for 2002 Chevy cavalier 2.2 engine?
Where is the stater located on a Chevy Cavalier located?
Where is the PCV valve located on a 2002 chevy cavalier?
The PCV valve on a 2002 Chevy Cavalier is located on the back of the valve cover. It is a plug in type.
Where is the daytime running light relay located on a 2002 Chevrolet cavalier?
where is the daytime running light relay located on a 2002 chevy cavalier
Where is the computer located on a 2002 Chevy Cavalier?
On the dashboard section, behind the glovebox compartment.
Where is the O2 sensor located on a 2002 Chevy Cavalier Z24?
The 2002 Chevy Cavalier 02 sensor can be found attached to the air cleaner housing. The O2 sensor will be on the back side of the air cleaner housing.
Where is the fuel filter located on a 2002 Chevy Cavalier Z24?
look in front of the gas tank
How do you remove and replace wiper switch on 2002 Chevy Cavalier?
How do you remove and replace wiper switch on 2002 Chevy Cavalier
Where is the emergency fuel shut off on 2002 Chevy cavalier?
The 2002 Chevy Cavalier does not come with an emergency fuel shut off. However, there is a fuel connector that will turn the pump completely off. It is located on the back of the fuel tank.
Where is the fuel pump located on 2002 Chevy Camaro?
In the gas tank attached to the sending unit.
Where are the sparks plugs located on a 2002 Chevy cavalier?
They should be on the side of the cylinder head. they will have plug wires ging to them.
Low side service port is located in a 2002 Chevy cavalier?
The 2002 Chevy Cavalier low side service port can be found on the top of the air conditioner compressor. The low side service port will be labeled as the low pressure port.
How many oxygen sensors are in a 2002 Chevy cavalier 2.2 liter?
A 2002 Chevy Cavalier 2.2 liter has a total of 1 oxygen sensor located in the exhaust manifold. It constantly monitors oxygen levels in the exhaust to allow the computer to make mixture adjustments.
