answersLogoWhite

0


Best Answer

I had to replace mine and it was under the car on the passenger side between the firewall and the transmission. It is quite easy to change

*WARNING* when you take it out be sure to have something to catch the Transmission Fluid. After all the research I did and mechanics I talked to I was not told of this happening until I changed it. Over all its not hard to change but again when you pull it out transmission fluid will come pouring out!!!! Let me know if this helps or not.

User Avatar

Wiki User

โˆ™ 2011-08-21 21:17:09
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides

๐Ÿ““
Create a Study Guide

Add your answer:

Earn +20 pts
Q: Where is the output transmission speed sensor on 2001 Chevy Malibu?
Write your answer...
Submit
Related questions

Where is the crank shaft sensor located on a 2010 Chevy Malibu?

2010 chevy malibu intake position sensor


Is it difficult to change the fuel sensor on a 2007 Chevy Malibu?

is it difficult to change the fuel sensor on a 2007 Chevy Malibu


Where is the fuel shut off sensor located on a 2000 Chevy Malibu?

fuel shut off sensor located on Chevy Malibu


Where is a egr pressure sensor located on a 1999 Malibu?

Where is located pressure sensor on Chevy Malibu 1999


What is a transmission range switch sensor in a 2001 Chevy Malibu?

it tells the cars pcm what gear the transmission is in. it also will not let the car start unless the transmission is in neutral or park.


Where is the 2003 Chevy Trailblazer speed sensor located?

The 2003 Trailblazer speed sensor is mounted on the transmission. It is on the passenger side of the output end.


How you change transmission fluid chevy Malibu 2005?

To change the transmission fluid on your Chevy Malibu 2005, first, pull off the pan, drain the fluid, and replace it.


Where is the crankshaft position sensor 2004 Chevy Malibu?

The 2004 Chevy Malibu crankshaft position sensor location is dependent upon the type of engine. In most cases the crankshaft position sensor is on the back of the engine.


Where is the crank position sensor for 1997 Chevy Malibu?

The 1997 Chevy Malibu crankshaft position sensor can be found on the back of the engine. You will need to remove the rear engine cover in order to access the crankshaft position sensor.


Where is the speed sensor on a 2003 Chevy Silverado located?

If it is 4WD it will be on the output housing (rear) of the transfer case. If not 4wd it will be on the output of the transmission. Typically has two wire connector.


How can you tell if the transmission on a 1998 Chevy Malibu is going bad?

You can tell if the transmission, in your 1998 Chevy Malibu, is going bad. If there is a whining or clunking noise. The transmission might cause your engine to install when you are stopped with your foot on the brake.


Looking for chevy venture 2001 speed sensor that is located in the transmission?

where is the speed sensor for the transmission located in 2001 chevy venture


What type of transmission fluid goes in a Chevy Malibu?

Dextron


What brand of transmission fluid does Chevy Malibu use?

Dexron


Where is coolant temp sensor locates on 1998 Chevy Malibu with 3.1?

Where is coolant fan switch located on 1998 chevy Malibu with 3 .1


How do you replace a input turbine sensor on a Chevy Cobalt?

The sensor is located on top of the transmission, and should be easy to unscrew. It is recommended that you change both input and output at the same time.


What type of transmission fluid goes in a 2004 Chevy Malibu?

A 2004 Chevy Malibu uses standard Dexron III transmission fluid. This is a widely available fluid used by many GM vehicles.


Where is the low input speed sensor located in a 99 Chevy Malibu?

Where is my veh.speed sensor input location


1998 Chevy Malibu has to be warm to shift into gear?

Check your transmission.


Transmission fluid type for 2003 Chevy Malibu?

Dexron VI


What is the transmission fluid capacity for the 2002 Chevy Malibu?

9 liters


How many quarts of transmission fluid are used for a 1997 Chevy Malibu?

I used up to 4 on my 1998 malibu.


Where is auto transmission dipstick located 2002 Chevy Malibu?

200 Chevy Malibu has a sealed system, so it does not have a dipstick to check the transmission fluid. If there are issues, one has to check the fluid while the car is running.


What is the labor time to replace a transmission in a 2005 Chevy Malibu 2.2L Eco?

what is the labor time to replace a transmissian in a 2005 chevy malibu 2.2l eco


Where is the IAT sensor on a 93 Chevy s10 blazer?

The 1993 Chevy S 10 Blazer IAT sensor can be found on the top of the transmission. The IAT sensor will be near the front of the transmission.