Oxygen Sensors
GMC Envoy
Nissan Pathfinder

Where is the oxygen sensor on a 1990 pathfinder located?

181920

Top Answer
User Avatar
Wiki User
Answered
2006-11-10 17:10:08
2006-11-10 17:10:08

The oxygen sensor is located on the exhaust manifold and is the only item on the exhaust with wires going to it.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


The 1990 Buick LeSabre oxygen sensor is located on the outside of the air cleaner housing. The oxygen sensor will be on the back side of the housing.

it is located on the ehaust manifold under the car

in the exhaust manifold. is there any place to buy a used one?

O2 sensor on 1990 Dodge Dakota is located on passenger side of exhast before catalytic converter. Most likely it has 4 wires.

Where is the camshaft position sensor located on 1990 Lexus ls400?

The automatic transmission temperature sensor, on your 1990 Mitsubishi, is located on the top of the transmission. The sensor will have to electrical wires going to it.

The 1990 Toyota speed sensor is located on the back of the transmission. There also is a speed sensor on the front passenger wheel.

The 1990 Geo Tracker IAT sensor is located on the top of the transmission. The IAT sensor will be near the back of the transmission.

Near the starter on the exhaust header. If it is 1990 it will be fun to break the rusty sensor out of the truck. good luck

I found this response to this question online. Hope it helps. http://autorepair.about.com/library/a/1c/bl419c.htm

All O2 sensors are located in the exhaust manifolds and in the exhaust front pipes close to the catalytic converters.

it is in the exhaust manifold,or exhaust pipe...

The PCV valve is located under the MAP sensor on a 1990 Pontiac Grand Prix. The MAP sensor is in the upper plenum.

O2 sensors are always located on the exhaust system.O2 sensors are always located on the exhaust system.

it is in the engine compartment on the right side, a small metal filter

The vehicle speed sensor is on the transmission. The ABS speed sensor is on the differential.

There was no 1990 Chrysler Cirrus. Look on the intake manifold or hoses for the intake temp sensor.

The coolant fan switch is located close to the thermostat.

The map sensor on a 1990 Ford 5.8 EFI Bronco is on the passenger side. It is located on the firewall.

how to replace the water pump on a 1998 Honda Accord

It is screwed into the exhaust manifold on the back of the engine.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.