On a 1990 Toyota pickup with a 2.4-liter engine, the oxygen sensor is typically located on the exhaust manifold or just downstream in the exhaust pipe. It is usually positioned before the catalytic converter. To access it, you may need to lift the vehicle for better clearance, and it can be identified by its wiring harness connected to the sensor.
Intakevalve side middle of moter on top
http://www.ncttora.com/fsm/1993/engine/92volumeai.pdf
There are 3 Oxygen Sensors on a 97 Toyota Camry with a 3.0 liter v6.An oxygen sensor is mounted on each exhaust manifold (left and right), And the third is mounted on the exhaust pipe after the catalytic converter.
On a 2005 Ford F-150 : ( for the 4.2 liter V6 , 4.6 and 5.4 liter V8 engines ) Bank 1 is the passenger side of the engine Sensor 2 is in the exhaust AFTER the catalytic converter
No , the 3.0 liter V6 engine in a 1994 Toyota pickup is NOT an interference engine ( according to the Gates website )
Where is crankshaft position sensor located on a 1996 Toyota corolla 1.6 liter?Read more: Where_is_crankshaft_position_sensor_located_on_a_1995_Toyota_corolla_1.6_liter#ixzz1nWxVCKMW
2.4 liters
Can you show me a diagram of the upstream oxygen sensor on a 3.5l liter Oldsmobile Intrigue engine?
The 2002 Toyota Tacoma 3.4 liter engine IAT sensor is located on the outside of the air cleaner housing. The sensor is on the back of the housing.
You will have to remove starter, It is behind the starter in the block.
Passenger side of engine block.
Doesn't have one, it has a distriburator