0
on the passenger's side of the firewall, just under the cowl.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is the pcm fuse located on a 2006 dodge ram 1500 with a 5.7 engine?
the pcm fuse on the 06 ram 1500 is #31
What numbers do you need to match up on the pcm on a 2004 dodge ram 1500 to replace it?
The part numbers that needs to match up on the PCM on a 2004 RAM 1500 should start with a 0 and end with 2 letters.
Where is the PCM Power Control Module located on a 2004 Dodge Intrepid?
The 2004 Dodge Intrepid PCM power control module can be found on the firewall in the engine compartment. The PCM power control module will be on the passenger side of the firewall.
Where is the ignition module on a 2004 dodge ram 1500?
Inside the PCM, far pass side under hood, on the firewall.
Where is the pcm fuse located on a 2007 dodge ram 1500 with a 5.7 engine?
the fuse for the 07 ram 1500 5.7 hemi is the same as the 06, #31
Where is ECM located on Dodge Ram 1500 2002?
The PCM (engine computer) is located under the hood, on the passenger side of the firewall.The PCM (engine computer) is located under the hood, on the passenger side of the firewall.
Why does your 2004 dodge ram 1500 say no bus and sometime stalls out when you crank it and nothing on the instrument panel works?
No bus means there is no signal from the PCM,most likely a bad PCM,but check all your fuses and connections on PCM
Can you take apart pcm on 2001 dodge ram 1500?
Not with out destroying it.
Where is the pcm located on a 1999 dodge stratus?
The 1999 Dodge Stratus PCM valve can be found on the outside of the air cleaner housing. The PCM valve is located on the back of the housing.
Where is the governor on a 4.7L 2006 dodge ram 1500?
It is part of the PCM programming.
Were is transmission control module located on 2000 dodge 1500 pickup?
PCM powertrain control module is located on the firewall on the passenger side. it has 3 large wire connectors.
Is it possible to reprogram a pcm for a 2004 dodge stratus from another 2004 stratus?
No, the dealers scan tool is required to program a PCM
