*** Caution ***Never open, service or drain the radiator or cooling system when hot; serious burns can occur from the steam and hot coolant. Also when draining engine coolant, keep in mind that cats and dogs are attracted to ethylene glycol antifreeze and could drink ant that is left in an uncovered container or in puddles on the ground. This will prove fatal in sufficient quantities. Always drain coolant into a sealable container. Coolant should be reused unless it is contaminated or is several years old. Heater Core 1. Disconnect the battery ground cable 2. Drain and recycle the engine coolant. 3. Remove the instrumental panel. 4. If equipped with the 5.4L 4V engine, remove the junction block splash shield. 5. If equipped with the 5.4L 4V engine, remove the bolts and disconnect the cable ends from the starter relay. 6. If equipped with the 5.4L 4V engine, remove the junction block bracket. 7. Disconnect the heater core hose couplings. 8. Remove the retaining screw and remove the A/C plenum demister adapter. 9. Disconnect the vacuum line from the A/C plenum demister adapter. 10. Remove the heater core bracket. 11. Remove the 13 plenum chamber top retaining screws. 12. Remove the plenum chamber top. 13. Remove the blend door assembly from the case. 14. Remove the heater core. 15. The installation is the reverse of the removal.
It's on the back of the intake plenum.
You can find the PCV valve beneath the MAP sensor located in the plenum at the right front of the engine.
I noticed that " Helpfull " had answered that the air suspension relay on a 1998 Ford Expedition was located on a bracket by the passenger side headlight . ( he came up with the answer after doing a Google search about 21 hours ago - was the answer not correct ? )
right in front of the engine under the intake plenum
The plugs are located under the intake plenum. This is a real job because it takes removing several bolts, wires and gaskets to get to them.
The oil filter on a 1998 Ford Expedition 5.4 Triton engine is located just behind the bumper on the drivers side. Im not sure of the answer above for on my 98 expedition (5.4) the oil filter is located on the engine(drivers side), nothing near the bumper.
any pictures
In the fuse panel located below and to the left of the steering wheel by the brake pedal , in location # 1 - 15 amp - flasher relay ( according to the 1998 Expedition owners manual )
The fuse that controls the fuel pump, on your 1998 Ford expedition, is located in the fuse box in the engine compartment. A diagram outlining each fuse is located on the inside of the fuse box cover.
the blower control switch pulls out
under the front bumper on drivers side
On my 1998 Ford Expedition XLT. The oil filter was located on the drivers side behind or near the front bumper.