0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is the cylinder position sensor on a Honda Prelude?
The cylinder position sensor is located in the distributor.
What are the two positions of a cylinder?
A cylinder doesn't move, it has one position.
What is Camshaft Position Sensor A Bank 1 Circuit Malfunction?
This. is the sensor found on the cylinder head in the vicinity of the camshaft which inform the ECM of its position, so the. spark.could be sent to the cylinder for ignition.of the cylinder.
Where is cylinder 1 on vw jetta 2.0 engine?
The cylinder. Positions are marked on the main front pulley. Manually turning the pulley to the number one position and the number one cylinder will be in position.
What is bore and stroke in a motorbike?
Bore is the diameter of the piston/cylinder, stroke is the distance the piston can travel between its highest position and its lowest position in the cylinder.
When you turn the key to the start position it only goes to the on position?
Ignition switch lock cylinder
Where is the camshaft position sensor on a 4.6L?
The camshaft position sensor on a 4.6 liter engine is positioned on the side of the motor on the front of the cylinder head. A 4.6 liter engine has a camshaft position sensor on each cylinder head.
Where is the crankshaft position sensor on a 2002 Dodge Dakota 3.9L v6?
The crankshaft position sensor goes through the bellhousing behind the passenger side cylinder head.The crankshaft position sensor goes through the bellhousing behind the passenger side cylinder head.
Where is the camshaft position sensor on a 1999 Chrysler Sebring?
On the six cylinder, it is inside the distributor. On the four cylinder, it is on the driver side end of the cylinder head.
Where is the camshaft position sensor on a 2000 Chrysler sebring?
On the four cylinder, it is on the driver side end of the cylinder head. On the six cylinder it is inside the distributor.
Position of number one cylinder on amc 360 engine?
The location of number 1 cylinder is front left.
Is there a certain position the electrical ignition switch for a 1994 Explorer has to be set to for the key cylinder to work properly?
If you are talking about installing or removing the ignition lock cylinder I believe the key has to be in the run position.
