The fill tank is part of the pully system right behind the fan-should be lower right side if you are facing the block. The fill tank is part of the pully system right behind the fan-should be lower right side if you are facing the block.
To repair a horn on the 1978 Chevy pickup, first check to make sure the wiring is correct. Then, remove the steering wheel cover in order to check to be sure the wiring is connected to the steering wheel.
Remove the belt for am your power steering pump. Remove the power steering pump hose. Remove the power steering pump retaining bolts. Reverse the process to install your new power steering pump.
1978 Chevrolet Big10 pickup
u have to pull the whole distributer to change the pickup coil
what is the firing order for 76 Chevy c10 pickup
No it will not.
Dextron II fluid.
Into the power steering pump reservoir.
The one that came in it works quite well.
Yes but you might have to change the driveshaft
Any steering column from a 1978-83 Chevy Malibu, 1978-87 El Camino, 1978-88 Monte Carlo could work, depending if it's a column or floor shift
replace the part leaking
I think it is around 160
Below the alternator - driver's side.
Yes, there is a nylon ``sock`` on bottom of fuel pickup.
Pull the power steering pump off.
check your wiring to the motor, if you have a hot lead on it, figure out why.
The 1978 Corvette had power disc breaks. This year and model was also the Silver Anniversary for the Chevy Corvette , it was also the Pace car for the Indy 500.
You need to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library. You will also need a pitman arm puller.
You need to get a FACTORY shop manual as none of the others have a good schematic of the steering column. Try AUTOBOOKSONLINE.COM or E-bay.
Probably around 5000-5500 pounds. It should list it on the driver door.
YES it will.
Yes it will.
Yes, There the same.