Remove the belt for am your Power Steering pump. Remove the power steering pump hose. Remove the power steering pump retaining bolts. Reverse the process to install your new power steering pump.
Into the power steering pump reservoir.
No
Any steering column from a 1978-83 Chevy Malibu, 1978-87 El Camino, 1978-88 Monte Carlo could work, depending if it's a column or floor shift
replace the part leaking
In a 1978 Corvette, the power steering fluid is stored in the power steering pump reservoir, which is typically located near the front of the engine, on the driver's side. You can identify the reservoir by its cap labeled "Power Steering." To add fluid, ensure the engine is off, remove the cap, and pour in the appropriate power steering fluid until it reaches the recommended level. Always check for leaks and ensure the system is functioning properly.
I think it is around 160
Below the alternator - driver's side.
The 1978 Chevy Nova shares steering column compatibility with several GM models from that era, including the 1978-1988 Chevy Malibu, 1978-1987 Pontiac Lemans, and 1978-1986 Oldsmobile Cutlass. Additionally, some columns from other GM A-body vehicles may also fit, but it's essential to verify specific features such as length and mounting points. Always check for compatibility with wiring and ignition systems to ensure proper function.
How do you change the heater core on a 1978 Chevy Nova Custom with a 305 v8 engine and where is it located on the car? thanks jj
To repair a horn on the 1978 Chevy pickup, first check to make sure the wiring is correct. Then, remove the steering wheel cover in order to check to be sure the wiring is connected to the steering wheel.
Pull the power steering pump off.
On a 1978 Chevy Cheyenne truck, the ignition switch is typically located on the steering column, just behind the steering wheel. You can access it by removing the plastic cover around the column. The key slot will be positioned at the front of the ignition switch, allowing you to insert the key to start the vehicle.