It's pretty easy to replace the Power Steering Fluid Pressure Switch (PSPS)
1. Disconnect the negative battery terminal.
2. Raise the vehicle.
3. Disconnect the electrical connection from the power steering switch.
(You'll find the PSPS on the backside of the power steering assembly. To unplug the electrical connection, pry up on the locking tab to release it.)
4. Using a deep socket and an extension, unscrew and remove the PSPS.
5. Seal the threads of the new switch with Teflon tape.
6. Installation is the reverse of removal. Be sure to tighten the switch securely.
The power steering pressure switch, on a 1993 Chrysler New Yorker, is located below the power steering pump. The pressure switch is attached to the power steering reservoir mounting bracket.
A Chrysler PT Cruiser does not have a kill switch.
It is on the back of the engine, just above the oil pan.
A 2004 Chrysler PT Cruiser does not have a kill switch. The fuel system is computer controlled with a relay.
The high pressure AC switch on a 2002 Chrysler Sebring is located on the passenger side of the engine bay. It is paired with the low pressure hose and is mounted near the coolant and power steering reservoirs.
Power steering pressure switch.Power steering pressure switch.
The oil pressure switch is in the middle of the engine, back side, a little left about half way up the engine.
Chrysler does not use reset switches.
Dealership, parts store, etc.Dealership, parts store, etc.
Chrysler vehicles do not have inertia switches.
Chrysler does not have inertia or reset switches.
Chrysler products do not have kill switches.Chrysler products do not have kill switches.