The radius arm is part of the front suspension - connecting from the control arm to the frame. The bushing is at the end that connects to the frame.
See "Related Questions" below dealing with the Windstar control arm.
where is the tcm in a windstar 2000 located
On a 1999 Ford Windstar : What Ford refers to as the " service panel " is located in the cargo area on the passenger side of the vehicle
Actually , the engine on a 2001 Ford Windstar is fuel injected so there is no carburetor
According to the 1999 Ford Windstar Owner Guide : " behind the access panel located on the right rear quarter panel interior trim "
You have to replace the strut rod bushing there are two in each strut rod inner and outer bushing then you could tight them again. the one you have is already shrink.
The speed control device or speed sensor on a 1995 Ford Windstar is located on the transmission. It is a plug in just behind the bell housing.
on top of the transmission
On a 1999 Ford Windstar, the expansion valve is located just inside the rear hatch of the rear panel on the driver's side. It is connected to the rear evaporator core.
in the gas tank
electronic module
On a 1999 Ford Windstar : ( relay # 207 is the fuel pump relay ) In the Power Distribution Box ( which is " live " ) located in the front of your engine compartment , near the battery
The vacuum modulator on aÊ2001 Ford Windstar is located in the front left area under the hood. It is connected to the transmission by wires and tubing.