in the door lock itself...kinda tricky to get to though
Remote Control Door Lock Receiver
The door lock remote control receiver for a 1997 Chevy Astro van is located inside the cabin. it is found on the right kick plate.
The SECURITY+ Universal Remote Control Conversion Kit consists of a receiver and remote control(s). This accessory will convert almost any garage door opener to rolling code technology. The remote control sends a coded signal from outside the garage. Inside the garage, the plug-in receiver accepts the transmitted signal and starts the door opener. With Security+, the code between the remote control and the receiver changes with each use, accessing over 100 billion new codes.PROGRAMMING THE RECEIVER The receiver and remote control(s) have been factory preset with a matching code. The door will open when you press the LARGE push button. You can activate your opener with up to eight SECURITY.I. remote controls (with blue push buttons) and one SECURITY+ Keylees Entry.If you purchase additional remote controls to operate this receiver: 1. Remove the receiver actuator cover. 2. Press and HOLD the selected remote control push button (Illustration A). 3. Then press the SRT (learn) actuator on the receiver (Illustration B). The adjacent indicator light will FLASH. Release the remote control push button. The opener will now operate when either the receiver actuator or the remote control push button is pressed. NOTE: If the remote control push button is not held down until the receiver Indicator light flashes, the receiver will not learn the code. To erase ALL remote control codes from memory: Press and HOLD receiver SRT actuator. Indicator light alongside will glow. When the Indicator light turns OFF (in about 6 seconds) ALL codes will be erased. 3-Function Remote Control A Select a remote control push button to operate receiver UnlversalReceiver SRT Actuator Light THE REMOTE CONTROL BATTERIES Open this end first to avoid cracking housing. Twist to open The lithium batteries should produce power for up to 5 years. Replace batteries positive side down, as follows: Use the visor clip or screwdriver blade to pry open the case as shown. To replace the cover, insert the 3 tabs at the opposite end and snap shut.Make sure you are using security plus remotes with blue buttons. Simply press and hold the button on the remote and then press the srt learn button on the receiver and the light bulb should flash. If this does not work you either have a bad remote, receiver or wiring. Make sure the wiring is good and hooked up to the push button terminals.
the remotes have an embedded serial number the receiver on the opener has has a button you press to make that remote a part of its friendly list. just push the button on the receiver while pushing the button on the remote
The heater door control on a Blazer can be replaced by purchasing a new one. The heater vent will pop out with a little nudge from a flat tipped screw driver. Then insert the new heater vent door control.
i am not sure what you mean. do you mean how do you program the keyless remote. if so try this link http://www.blazerowners.com/keyless.htm
The remote needs a new battery.
IF MY GARAGE DOOR REMOTE IS NOT WORKING AS WELL AS IT ONCE DID, IS THERE A BATTERY IN IT THAT NEEDS TO BE REPLACE??
on my 1996 it is on your left
The one inside the drivers door. It will be on the side of the dashboard. A square door
Best Buy or Walmart:)
For some of them, GTS is supposed to come with a remote door control. If you are talking about remote starter, then you have to install it by yourself.