The inertia switch would only be tripped by an impact. It is possible the switch is defective or broken. You would need to check whether the pump circuit is getting power to be sure. The fuel pump could also be bad.
If you mean the reset button on top of the FUEL PUMP SHUT OFF SWITCH the switch is located in the drivers footwell , behind the kick panel , by your left foot ( there is an access hole ) on a 2000 Mercury Villager
There is no separate switch for it. Pushing the light switch will defeat the dome and courtesy lamps.
In the drivers footwell , behind the kick panel . There is an opening in the kick panel to access the red reset button on top of the switch
The 1995 Mercury Villager turn signal relay switch is located beneath the drivers side dashboard. The turn signal relay switch will be left of the brake pedal.
The switch just pops out of the dashboard.
It's part of the range switch on the transmission.
If you mean the starter solenoid, it's on the starter.
On the brake pedal.
Usually on the dash to the right of the steering wheel.
On the brake pedal assembly.
The "Fuel Shut-Off Reset Switch" on a 1995 Mercury Villager should be in the same location as on the 1996 model. Look below the Hood Release Latch on the lower side kick panel. There is a red button that can be accessed through a small opening on the kick panel. Once the button is in the lower position, you will have to pry the kick panel off and use a small regular screwdriver to pop the button back up by putting the screwdriver into a small slot just below the button.
There is only the speed sensor and the range switch.