Inside the transmission, on the valve body.
Inside the transmission, on the valve body.
see answer for the 1999 Breeze
Plymouth does not use inertia switches.
Plymouth does not use inertia/reset switches
Time for a new car ! Not a Chrysler product !
Plymouth does not use inertia\reset switches.
Plymouth does not use inertia/reset switches.
Chrysler/Plymouth vehicles do not use inertia/reset switches.
You have a defective switch, most likely.
Plymouth does not use inertia/reset switches.Plymouth does not use inertia/reset switches.
Check the engine ground before replacing parts. I have a 97 Plymouth Breeze that would not turn over, but the lights and radio worked. After replacing 4 parts (starter/solenoid, ignition switch, crank case sensor and safety switch), it turned out that the engine was not grounded properly. Once the ground was reattached correctly, car started.
It is the turn signal switch combined with the head lights, wipers, etc.
The neutral switch on a 2000 Plymouth Breeze is typically located on the transmission. It is usually mounted on the side of the transmission case and is connected to the transmission linkage. This switch helps ensure that the vehicle can only be started when it is in the "Park" or "Neutral" positions. Always consult the vehicle's service manual for precise location and troubleshooting steps.