Hmmm, which sensor? There are like 20 or so sensors on the car. :) The vehicle speed sensor is located under the intake manifold or the right side of the car ( sitting in it ) right beside the rear motor mount on the same side, It can barely be seen with the intake manifold on, and I would hazard a guess it is impossible to remove with the intake on. The sensor itself is on top of what you think the sensor is, the device below it simply turns a small shaft that turns the sensor, look for two small lines going to this power shaft and you will be very close
How can I check the ENGINE COOLANT TEMPERATURE (ECT) sensor on my 1991 HONDA PRELUDE SI 2.1L
On a 1991 Honda Prelude 2.1SI, the Oil Sensor is located slightly above the Oil Filter.
reset the brakelamp light on the dashboard - Honda prelude 1991
It depends on which version of Prelude (there were five generations) you are referring to.
one is located at the thermostat housing. the other is in the bottom of the radiator.
Yes it does
The cylinder position sensor is located in the distributor.
The IAT sensor on the 1993 Honda Prelude is located to the right of the intake manifold as you face the engine compartment. It is connected with red and green wiring.
In the tank
show me picture of where the water pump is located on 1991 Honda prelude si
The diameter of the rims for the 1991 Honda Prelude is six inches. Check out a local car dealership for more information about the car or if interested in purchasing it.
under the distributor!
Honda Prelude 1979-1991 have the same bolt pattern so they will "fit". Then it just depends on the width of the wheel and the offset (the distance between the centerline of the wheel and the plane of the hub-mounting surface of the wheel). Honda Prelude 1992+ wheels will not fit.
The O2 sensor on a Honda Prelude is found on the exhaust pipes of the vehicle. They are located near the catalytic converter which is place on the underside of the chassis.
The oxygen sensor on a 1988 Honda Prelude fuel injected engine is on the exhaust manifold. It screws directly onto the front of the exhaust manifold.
I have a 1990 prelude that is in the dealership as I write this to have the speed sensor replaced. I have just been told that it is on the transmition. It is a sensor.
Yes, the 1988 and 1989 Honda Prelude has a VSS that is a cable sending unit that connects to the gauge cluster in the dash.
Just below the intake manifold.
Behind the timing belt cover
A 91 prelude gets about 26mpg in the city and about 30 on the highway.
it should have a b21. 2.1L.
under the battery
A low oil level can cause the oil light to blink on a 1995 Honda Prelude. A faulty sensor can also cause this.