answersLogoWhite

0


Best Answer

The speed sensor is located on the back of the transmission, right before you get to the drive shaft you will see it sticking out.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the speed censor in 1996 Mercury Cougar v'8 located?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is vehichle speed sensor in mercury cougar?

Where is speed censor on mercury cougar


How much does a Mercury Cougar weight?

My 1991 Mercury Cougar LS 3.8 4 Speed Automatic weighs in around 3800lbs.


Which was the maximum speed of Mercury Cougar RX-7 automatic 8cyl 285HP 1971?

The maximum speed of a 1971 mercury cougar RX-7 automatic 8cyl 285HP is 110 mph or 177.02kph.


Where is the speed sensor located on a 2000 mercury cougar?

As general rule speed sensors on cars were always located in the gearbox or automatic transmission. This would be the first place to start, however modern transmissions have the sensors built in and its unlikely they are user changeable.


Where is the speed censor located in a Chevy s10 4wheel drive truck?

In the back end of the transmission.


How do you bypass the govenor on a 1996 Mercury Cougar XR-7 V8?

It does not have a govenor. Speed is computer controlled.


What is the Mercury Cougar Turbine Shaft Speed Sensor for?

are you sure it is not tail shaft sensor. This would be for your speedometer


Where is the blower motor resistor on a 2000 Mercury Cougar?

In the black box right beside the battery. There are 2, a high speed and low speed relay.


Fuel consumption for a 1987 mercury cougar 3.8 v6?

According to a website I was looking at : For a 1987 Mercury Cougar , 3.8 liter V6 , 4 speed automatic transmission ( 17 city / 24 highway , miles per U.S. gallon )


1992 v6 Mercury Cougar how many mile per gallon do you get?

According to a website I was looking at : For the 1992 Mercury Cougar , 3.8 litre V6 , 4 speed automatic transmission : ( 18 city / 25 highway , miles per U.S. gallon )


What is code P1506 for a 1999 mercury cougar means?

Code P1506 - Idle air control valve over speed error


If you replaced the blower motor switch resistor on a 1999 Mercury Cougar because the blower only worked on high speed and now you have no heat what could be the problem?

It is probably the resistor. I had the same problem with my 99 Cougar. It is located on the passenger side under dash. Check with Ford. I think that this part was recalled.