tranny... Everyone should have a manual, and the library should have a professional shop manual available for copies in the reference section...read up and fix 'em like the pro's...! :) Dave
The coolant temperature sensor on a 2005 Dodge Neon is located on the cylinder head. It is close to the camshaft position sensor.
The temp sensor is part of the overdrive solenoid inside the transmission, on the valvebody.
4 cylinder it is on the end of the head. 6 cylinder it is in the distributor.
The cam sensor is on the driver side of the cylinder head.
The crankshaft position sensor on a Dodge 5.9L V8 is located behind the passenger side cylinder head, and it aims at the flywheel through a hole in the bell housing.
Its located on the firewall... it is just sticking out, it has a 3 wire connection to it as well as a vaccum line coming from it.
2006 was the last Neon. The cam sensor was located on the driver side end of the cylinder head.
On a 3.0 liter v6 the crank sensor is located on the bell housing of the trans.It has a wire coming out at the top right of bell housing. The cam sensor is in the front of the engine near the serpentine belt.
Bank 1 refers to the side of the engine where the number 1 cylinder is located and sensor 2 is the down stream or after the catalytic converter sensor.
4 cylinder it is on the end of the head opposite the timing belt. 6 cylinder it is part of the distributor.
The cam sensor is the "pick up plate" in the distributor, under the rotor.
It goes into the top of the bell housing behind the passenger side cylinder head.
drivers side just in front of transfer case the sensor is yellow the only one in that area.
On the 4 cylinders it is in the rear of the block. On the 6 cylinder it is in the top of the bell housing.
On the driver side end of the cylinder head.
A 2006 Dakota does not have a mass airflow sensor.A 2006 Dakota does not have a mass airflow sensor.
where is the crankshaft sensor located on a 1993 dodge intrepid
The sensor is located inside the distribuitor
The cam sensor on the 4 cylinder is on the end of the head. On a 6 cylinder it is on the front timing cover.
It is located between the cylinder heads, on the top of the block.
Under the very front of the pasenger side cylinder head.
Underneath the front outside corner of the passenger side cylinder head.
where is the engine speed sensor located on a 1999 dodge stratus 2.4 l
The camshaft position sensor on the Neon 4 cylinder is located at the driver's side of the head in line with the camshafts, just below the valve cover
The oxygen sensor is located in the exhaust system on a 2005 Dodge Durango Hemi 5.7. There is a sensor located before and after the catalytic converter.