Car Computers and Sensors
Mercury Villager

Where is the speed sensor on a 1993 Mercury Villager?

131415

Top Answer
User Avatar
Wiki User
Answered
2008-12-04 12:34:41
2008-12-04 12:34:41

The VSS is located on the bottom of the transaxle beside the exhaust manifold.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


the elictronic control sinsor at on a 93 mercury villager


Mercury Villager was created in 1993.


The MAP sensor should be on the firewall just above the brake booster.


No, the 3.0 V6 in a 1993 Mercury Villager is NOT and interference engine.


There are ( 2 EXHAUST MANIFOLDS ) on your 1993 Mercury Villager 3.0 liter V6 engine


The IAT is located in the air intake tube before the MAF.


The cruise control module of a 1993 Mercury Villager is located under the passenger side of the dashboard.



If the 1993 Mercury Villager runs rough when the check engine light comes on and the code reader says 34 and 51, there is a problem with an oxygen sensor and the MAP (Manifold Absolute Pressure) sensor. Both parts together will cost around $200.


Yes, the 1993 Mercury Villager was a 1992 Nissan Quest. The last year Nissan used a Carburetor on a Quest. Fuel injection system replaced the carburetor in 1993.


According to one of Ford's websites : The spark plug gap for a 1993 Mercury Villager , 3.0 V6 is : ( .032 inch )


The 1993 Mercury Villager takes 22" replacement windshield wiper blades on both sides front.


The cruise control computer module is located on the passenger's side of the engine compartment on a 1993 Mercury Villager.


According to fordparts.com the spark plug gap is ( .032 inch ) on a 1993 Mercury Villager with the 3.0 liter V6


Timing is set by the PCM and is not adjustable.




According to one of Fords websites : For a 1993 Mercury Villager , 3.0 liter V6 engine : ( the spark plugs are gapped at .032 inch )


I was looking at one of Fords websites and it shows for the 3.0 liter V6 engine in a 1993 Mercury Villager : The spark plugs are gapped at ( .032 inch )


No , according to the Gates website ( they make timing belts etc. ) the 3.0 liter V6 in a 1993 Mercury Villager ( is an interference engine )


There are a couple of reasons why a 1993 Mercury Villager is hard to shift. One reason could be a gear shift cable. Another reason could be low transmission fluid.


Your Villager has only one O2 sensor located on the front catalytic pipe before the converter. You should be able to look down between the engine and radiator and see it.


It is a very easy one. 1.2.3.4.5.6.



Timing is set by the PCM and is not adjustable.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.