Tailshaft of the trans.
also look under the hood just down line on the speedo cable from the fire wall there should be the speed sensor about 12 inches from where it enters the firewall coupled into the cable with a male and female connector spliced inline
from oakridge auto ,,wheeler WI
A Dodge B250 Van does not have a mass airflow sensor.
When those things on my 92 B250 did not work, I replaced the speed sensor located on the transmission tailshaft and that fixed the problems. Hope that helped! Mark When the speedometer and odometer did not work in my 1990 B250, I had to replace the speed sensor, instrument cluster (speedometer) and replace a tiny gear (odometer) in order to get them working properly
The coolant temp sensor is located next to the thermostat housing.
It is inside the distributor.
Driver side tail shaft of the transmission.Driver side tail shaft of the transmission.
The speed sensor, on your Dodge Stratus, is located on the back of the transmission. The speed sensor has a wire leading to the front wheel.
If a person recently changed the speed sensor in a 1990 Dodge B-250 Van and the trip meter and odometer do not work, there could be a fuse that needs to be replaced. The computer might also have to be reset to allow for the odometer and trip meter to work.
There are two speed sensors on a 1996 Dodge Avenger, an input speed sensor and an output speed sensor. Both are located on the front of the transmission.
The vehicle speed sensor is the abs sensor on top of the rear axle.
where is the engine speed sensor located on a 1999 dodge stratus 2.4 l
It does not use an input speed sensor.
There isn't an input speed sensor.