Ford Crown Victoria
Ford Explorer XLT
Ford F-250

Where is the speed sensor wire for 1994 ford crown Victoria 4 door?

161718

Top Answer
User Avatar
Wiki User
2006-03-13 05:19:52
2006-03-13 05:19:52

Wow, that is a little like asking "where is the wire in your house?" and you answer "in the floor, in the walls, in the ceiling, all over!" First of all there can be more than one speed sensor. The ABS uses several speed sensors,and there are two more speed sensors on the transmission. But I am assuming you want the one that runs the speedometer. That is the Vehicle Speed Sensor(VSS) located on the left rear of the trans tailshaft housing. The wiring runs from that sensor, all the way through the main trans wiring harness loom, up into the engine wiring harness loom, then into the PCM itself. But somewhere along the way, it splices out into another leg, which goes into the dash wiring harness loom, and into the instrument cluster assembly. The signal wire coming off that sensor, going to the PCM and speedometer is grey/black, and the ground wire for that sensor is pink/orange.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The transmission position sensor on the 1994 Crown Victoria can be replaced by first disconnecting the battery. The transmission sensor is located on the driver's side of the outer casing to the transmission. Unplug the old sensor and plug in the new one, then connect all of the wires to the new sensor, one by one. Then reconnect the battery.

User Avatar

Speedometer cable (most common) Speedometer head Gear on transmission end of speedometer cable

User Avatar

To empty an ashtray in a 1994 Crown Victoria you must remove the ashtray by applying forward pressure.

User Avatar

AnswerThis is the application for the Crown Victoria 1983-1992=AOD, 1993-1994=AODE, 1995-2006=4R70W and 2007-2009=4R75E

User Avatar

Actually , the 1994 Ford Crown Victoria is OBD I ( EEC IV ) so there will be an EEC TEST connection in the engine compartment

User Avatar

Speed sensor is on the rear differential.

User Avatar

For a 1994 Ford Crown Victoria : It has the 4.6 liter / 281 cubic inch Single Over Head Cam ( SOHC ) V8 engine from the factory

User Avatar

The vehicle speed sensor, on your 1994 Chevrolet Silverado pickup truck, is located on the back of the transmission. The speed sensor is labeled as such.

User Avatar

According to one of Ford's websites : For the 4.6 liter V8 engine in a 1994 Ford Crown Victoria : ( Motorcraft FL-820 engine oil filter )

User Avatar

5W-30 is the PREFERRED oil

User Avatar

If you are talking about a wheel speed sensor then the abs light will be on.

User Avatar

According to the engineer who designed it. No

User Avatar

Follow the top rad. hose. It's in there.

User Avatar

" regular " unleaded , 87 octane

User Avatar

You have to drop the fuel tank. It's in there.

User Avatar

Where is the vehicle speed sensor pick up located in a 1994 Pontiac Trans Port?

User Avatar

No, the 1983 - 1992 Crown Victorias used the AOD transmission and the 1993-1994 Crown Victorias used the AODE transmission, so they would be different. Sorry!

User Avatar

The vehicle speed sensor (vss) is generally located at the rear of the transmission.

User Avatar

speed sensor is located on the fron upper part of the differential the speed sensor ring is inside the diff housing

User Avatar

Should be 134, but, check with dealer first.

User Avatar

http://www.supermotors.net/registry/media/187927

User Avatar

The speed sensor(s) are located behind the brake discs on the front end


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.