everywhere i have read says it is the yellow/green wire in the driver kick off the ecu plug.
Yes but the 95 bell housing will need to be reused to the crank angle sensor can be retained
In a 1995 Nissan 240SX, the transmission wire color can vary depending on the specific function. Typically, the main transmission harness includes wires for the transmission position sensor, speed sensor, and solenoids. For accurate identification, it's best to refer to a wiring diagram specific to the 240SX model, as color codes can differ based on the vehicle's configuration and market. Always ensure to double-check with a reliable service manual for precise details.
where is the speed sensor located on a 95 eclipse 5 speed
Driver window is out of alignment on a 95 Nissan 240sx? what do i do
in the transmission
in the hub
the speed sensor senses the speed and tells your transmission when to shift , it also controls your speedometer.
Sure it will, they are the same motor.
To replace the knock sensor on a 1995 Nissan 240SX, first disconnect the negative battery terminal. Locate the knock sensor, which is typically found on the engine block or under the intake manifold. Remove the electrical connector and unbolt the sensor using a socket wrench. Install the new sensor, reattach the connector, and reconnect the battery terminal.
no different door the 93 will fit small on the 95
it will fit but you need to modify the mounts.
YES!