On the top of the tranny. There will be a black wire sticked in there. It`s on there loose, so you can just pull it out, or stick it in
there is 2 of them depending on what type of tranny you have, the MAIN sensor that makes the speedo work is located on the rear transfer case and NOT on the tranny itself. the other is a much smaller sensor that does go on the tranny but that ones DOESN'T effect your speedo. if you speedo is not working then its going to be the BIG sensor in the rear.
where the speedo cable connects to the transmission
No. The speed sensor is located on the transmission, and is what drives the speedometer cable, which drives the speedo head. The speedo head is another name for the the speedometer, which is the display gauge that you see while sitting in the car.
where is the speedo sensor on a renault kangoo 2001
located in the transmission case where the speedo cable connects
The location varies from vehicle to vehicle. It is usally located at the rear of your transmission, where the speedo cable used to be.
they dont have a cable they r sensor driven speedos on those cars
There is no speedo cable on a 96, GM quit using them in 1987. You have a speed sensor, which is located on the top rear of the transmission. It will have a couple wires coming off it in a plug, that run thru the computer, then to the speedo. If your speedo has quit working, has it also set a check engine light? If so, I would recomend replacing the speedo sensor.
There is no such thing as an "odometer sensor." There is a vehicle speed sensor that is located on the output shaft housing of the transmission. That sends info to the speedometer. From there, the speedometer and the odometer are both operated internally, so if your speedo is working, but the odometer isn't, you have a problem inside the speedo head assembly.
In the transmission tail section same place the speedo gear is.
It is an electric speedo so it can be the speed sensor or in the speedo itself.
If you don't have a speedo cable on your front wheel, you have a speedo sensor. I believe that change was made in 2000.