you add atf into the tube that houses the dipstick. you will have to use a funnel but it works.
Yes
Well fix it!
The flasher on a 1990 Mazda MVP is located under the dash on the driver's side. It is just above and to the left of the brake pedal.
what is the order of the cylinders on a 2003 Mazda MVP 3.0 v6
iac is bad need to be replace
5W-20 is recommended
question makes no sense
There is no fuel pump inertia switch on any Mazda. These are found on Ford vehicles.
Drive to any place that sells batteries and they can tell you the correct size to buy.
The chime may ring on a 2000 Mazda MVP if a door is open and the keys are not in the ignition because the car has a secondary alarm system that is letting the driver know that a door is ajar. If the door is opened while someone is sitting in the passenger seat it might go off before the person exits the vehicle.
To replace the speed sensor on a 2000 Mazda MVP, first, locate the sensor, typically found on the transmission. Disconnect the negative battery cable, then remove the electrical connector and the mounting bolt securing the sensor. Pull out the old sensor, install the new one, and secure it with the bolt. Finally, reconnect the electrical connector and the battery cable.
disconnect negative battery terminal depress brake petal fully for 30-45 seconds reconnect negative battery terminal