The location of the starter is underneath the intake manifold. You can just barily see it. In order to remove it, you must first remove two of the bolts, which are on the opposite side, on the transimision. It does help to remove the intake tubing come from the air filter to get to the bolts easier. The third and final bolt in on the starter side. I would very stronly recommend getting an air powered rachet, as there is NO room to really move a wrench (intake mainfold in the way. You will be doing most of this by feel, so it does help to have already purchase the starter and have it sitting there so you can see how the bolts are laid out. Have fun! Bryan Soemo email@example.com
The 1999 Kia starter looks like a round barrel. The starter is approximately 6.5 inches long. The starter will have two battery cable hose on the front of it.
starter on 1999 kia sephiathe starter on a 1999 kia sephia in located underneathe the intake manifold nearest to the drivers side if you look near the fire wall on the drivers side look where the transmission connects to the engine,, the starter is bolted to it right there, good luck with the procedure , its much easier to do it from up above the hardest part is unbolting the bottom bolt of the starter, there is 3 bolts in all and you're better of taking the starter out from the passenger side after you've unbolted it and unhooked your connections, you also must unbolt the the intake manifold support bracket
The speed sensor on a 1999 Kia Sephia is located on the transmission. It is just behind the bell housing for the transmission.
To replace a starter on a 98 Kia Sephia, turn off the ignition and disconnect the negative and positive battery cables.ÊDisconnect all the bolts that hold the starter to the block and replace with new.Ê
The 1999 Kia Sephia is compatible with Dexron III automatic transmission fluid (ATF). The Sephia can also use Dexron/Mercon and Mercon LV ATF.
how to set your gears for timing belt on 1999 kia sephia
There are 4.
The taillights on a 1999 Kia Sephia are replaced through the cars trunk. Remove the plastic covers from the light housings and replace the bulbs.
http://www.kiatechinfo.com/ it's free to register and has tons of info on any kia look under the "shop" link to get your answers in Set by set pictures
There are a few issues that can cause starting problems in the Kia Sephia. Some include a bad or drained battery, faulty starter, or a bad alternator.
the starter is on the side of engine between engine and firewall of car on driverside
in the fuel tank
Kia Sephia was created in 1994.
will a 2000 kia sephia dohc transmission fit on a 1995 kia sephia sohc block?
At rear of engine. Follow the pos battery cable/
Under the engine in the middle toward the back of the engine
it is under the intake manafold on the right side
The timing belt on a 1999 Kia Sephia is changed by removing the timing cover, loosening the tensioner, and pulling the belt off. A new belt is then put in place and then tension reapplied.
You have to remove the starter and run a new wire
0.28-0.32 in or .70-.80mm
washer pump located on kia sephia