answersLogoWhite

0

Where is the starter located on a 1987 Mazda RX7?

Updated: 8/20/2019
User Avatar

Wiki User

11y ago

Best Answer

The best way to access it is from under the vehicle . It's connected to the bottom of the gearbox with two bolts connecting it and a thick and thin wire.

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the starter located on a 1987 Mazda RX7?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where on your 1987 Mazda rx7 would you find the starter and were does the ground conect to it?

The starter is on the left side of the transmission. The starter grounds though itsself.


Where is the starter located on 1990 mazda rx7?

Underneath the car bolted to the bellhousing on the gearbox


Where is the starter relay on a 1983 Mazda rx7?

The SAC22 does not have a starter relay.


How do you change starter on 1983 Mazda Rx7?

ask autozone


What are the specs of a 1987 Mazda rx7?

http://www.petting-zoo.net/~gkm/rx7/specs.html


Where is the starter located on a 1988 Mazda RX7 With a Manual Transmission?

its on the tranny, drivers side lower porton of the bell housing


Where is the starter located on an 1987 Mazda rx7 manual?

The starter is located under the drivers seat beneath the car and is shaped sort of like a torpedo, I have great condition owners manual and have replaced that part once myself. If you need more clarifaction my e-mail is mgraf24@yahoo.com. Mike


Where is the fuse panel located on a 1987 Mazda RX7?

If you look on the driver side back by the break pedle you will see the fuse panel


How many gallons of gas does a 1987 Mazda RX7 hold?

16.6 gallons


Could you please tell where the starter is located on a 1984 Mazda RX7 GS?

located under driverside,about 20 inches away from the front wheel.it's tucked tightly up by the transmission.


Where is the fuel pump located in a 1990 Mazda rx7?

in the tank


Will a 1987 Mazda rx7 engine fit into a 1990 rx7?

yes, however you may need to adjust the wire harness to fit.