answersLogoWhite

0


Best Answer

I actually removed mine today i thought it went bad it was only the clutch inhibitor switch anyways the starter is located on the back side of the engine on the drivers side of the carthere are two bolts that your going to need to remove there like next to the throttle body then remove the two wires runing to it these are a little tricky i had to use a small ratchet to fit in there to the main and the smaller on just unclips then your going to have to slid it towards the passenger side of the car where theres an opening hope this helps you

User Avatar

Wiki User

โˆ™ 2007-07-22 02:51:17
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the starter located on a 1993 Nissan Altima?
Write your answer...
Submit
Related questions

How do you know if the starter needs to be replaced on a 1993 Nissan Altima?

How do you know if the starter needs to be replaced on a 1993 Nissan Altima?


When was Nissan Altima created?

Nissan Altima was created in 1993.


Where is the crank sensor located on a 1993 Nissan Altima?

There is none; it's the distributor.


1993 Nissan altima 2.4 where is the location of the crankshaft sensor?

Located in the distibutor!!


Where is starter located in a 1993 Nissan Sentra?

AnswerWhere can i find a diagram to locate where the starter is on a 1993 Nissan Sentra automatic


Why is your 1993 Altima Nissan making a clicking noise but does not start?

Why is your 1993 Altima Nissan making a clicking noise but does not start?


Where is the crank shaft sensor on a 1993 Nissan altima located?

I don't believe that the altima had a crankshaft position sensor until 1995.


Where is the pcv valve on the 1993 Nissan Altima?

== Answer The PCV valve on a 1993 Nissan Altima is located under the intake manifold just above the oil filter. You have easier access if the oil filter is removed. Not so easy...


Where is the oil pump located on a 1993 Nissan altima?

Bolted to the engine inside the oil pan


Oil capacity on a 1993 Nissan Altima?

The oil capacity on a 1993 Nissan Altima is approximately 4.1 quarts. The oil that should be used is 5W-30.


Where is the fuel filter on a 1993 nissan altima located?

as you face the front of the car it is slightly right on the fire wall.


Where is the radiator drain plug located on a 1993 Nissan Altima?

Should be located at bottom or rear of radiator or remove lower radiator hose


Does a 1993 Nissan Altima have an interference engine?

Yes it does


For how many years has Nissan been selling the Altima?

The Nissan Altima was introduced in 1993 as a replacement for the Nissan Bluebird. Originally, it was named the "Stanza Altima," before the model name was shortened to its current form.


Where is the starter relay located on a 1993 Nissan 240sx?

In the right fender right behind the battery


Where is the IAT sensor on a 1993 Nissan Altima?

its in the intake manifold


Does a 1993 Nissan Altima have a timing belt?

No, timing chain.


How long has Nissan been producing the nissan altima?

The first generation of Nissan Altimas was produced in 1993. The Nissan Altima is still being produced today, with a new 2010 design just being released.


Will a cv axle for a 1995 Nissan Altima fit a 1993 Nissan Altima?

yes 93-97 as long as there is not a difference in abs or limited slip diff


Where is the starter on a 1993 Nissan 300Z?

on the transmission


Where is the crank shaft sensor on a 1993 Nissan altima?

I don't believe that the altima had a crankshaft position sensor until 1995.


Does a 1993 Nissan Altima have a crank shaft sensor?

I don't believe that the altima had a crankshaft position sensor until 1995.


Why will the power antenna not retract on a 1993 Nissan Pathfinder?

I have the same problem on my Nissan Altima, it is the antenna motor. Replace it.


Does the 1993 Nissan Altima has a crankshaft sensor?

no. didn't come out until 1995


Where is the PCV valve located on a 1993 Nissan Altima?

AnswerIt doesn't have a PCV valve.Actually it does. The PCV valve for a 1993 Nissan Altima is located behind the engine below the intake. Buy a Haynes manual, the PCV is VERY tough to get too but it can be done. You can only get two bolts from the top but have to go from underneath the car to detach the hose.

Study guides

๐Ÿ““
Create a Study Guide