I actually removed mine today i thought it went bad it was only the clutch inhibitor switch anyways the starter is located on the back side of the engine on the drivers side of the carthere are two bolts that your going to need to remove there like next to the throttle body then remove the two wires runing to it these are a little tricky i had to use a small ratchet to fit in there to the main and the smaller on just unclips then your going to have to slid it towards the passenger side of the car where theres an opening hope this helps you
Nissan Altima was created in 1993.
There is none; it's the distributor.
Located in the distibutor!!
Take the steering column housing off (usually held by 4 screws from the bottom) and remove the starter cap from the back of the ignition cylinder. In a Nissan, the ignition cylinder usually has a T shaped pin which turns the starter. if you can start your vehicle by turning the starter cap with a screw driver, you probably don't have an issue with the starter.
I don't believe that the altima had a crankshaft position sensor until 1995.
Why is your 1993 Altima Nissan making a clicking noise but does not start?
Bolted to the engine inside the oil pan
== Answer The PCV valve on a 1993 Nissan Altima is located under the intake manifold just above the oil filter. You have easier access if the oil filter is removed. Not so easy...
as you face the front of the car it is slightly right on the fire wall.
The oil capacity on a 1993 Nissan Altima is approximately 4.1 quarts. The oil that should be used is 5W-30.
Should be located at bottom or rear of radiator or remove lower radiator hose
Yes it does