BOTH "302&400cid Engines of that era T-BIRDS positioned the Engine STARTER MOTOR ON THE PASSENGER SIDE OF THE"BELLHOUSING"
AFTER REMOVING 2 BOLTS & ONE POS.CABLE FROM THE STARTER HOUSING , THE STARTER WILL READY FOR REMOVAL
Have you checked the ignition switch on the column . I had to replace the one in my 1977 Trans Am.
If your starter is bad you simply replace it with another one.
How does one remove and replace the starter in the 1997 Bravada??
Hi You cant replace the selenoid you have to buy a new starter. No one sells selenoids for these starters.
Hi You cant replace the selenoid you have to buy a new starter. No one sells selenoids for these starters.
remove battery and tray, two, 17mm or 18mm bolts hold starter on. one on top of starter and one on bottom
you start by taking out the 2 bolts the hold the starter in,, then disconnect the wires and replace starter..er i mean disconnect wires first or one bolt then one wire then the other bold AND OTHER WIRE
In order to replace the starter on a 2004 Chevy Express, it is best to have the owner's manual handy to know and understand the parts of the car. One should also have a replacement starter before taking out the old starter.
Replacing the starter on a 1999 Monte Carlo is fairly easy to do. The car will need to be jacked up to reach the starter. The wires will need to be disconnected from the starter before removing it. After the wires are removed, the starter can be taken down by removing the two bolts. After the starter is removed, replace it with a new one.
take off old starter and install new one in its place. finished
First replace the cheap part, the starter relay. It is attached to the short positive battery cable; clean cables too. If no luck and your battery is good, replace your starter with a remanufactured one; don't try to fix an old starter.
disconnected the batteris - disconnet the wiring on starter motor,make not of the cables remove the two bolts securing the start to the car, installation is reverse Disconnect and REMOVE the battery. This allows you to get to the wires on the starter much easier. Then remove starter. Be sure to get the small bearing out of the housing and replace it. A new one should come with the starter, but if it does not, get one and put it in.