0
" The Pulsar starter is located centrally, underneath the engine close to the passenger compartment." According to my car, the E16i engine, it is on the drivers side of the engine below/behind the distributor.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What cars takes H6054 seal beam?
Nissan Pulsar NX
Does the 1990 Nissan Pulsar have a timing belt or chain?
The 1.6 litre four cylinder engine in a 1990 Nissan Pulsar NX has a timing CHAIN
How do you install an ignition module on a 1984 Nissan Pulsar NX?
its inside the distributor
Where is the wire you plug your lighter wire into in the dash of an 1985 Nissan Pulsar NX?
In the dash
Where can you get a engine wiring harness for a 1988 Nissan Pulsar NX?
The best place is to get it from a wrecking yard.
Where is the starter motor located on a Nissan nx coupe?
On the Nissan NX Coupe the starter is located to the right of the transaxle and to the left of the air cleaner. The air filter will need to be removed as well as the battery to access the starter motor.
What is the stereo wire diagram for 1987 Nissan Pulsar NX?
Follow my link http://viewmorepics.myspace.com/index.cfm?fuseaction=user.editAlbumPhotos&albumID=518816&MyToken=49aa20cb-7b44-4229-85c2-15c6cce75f59
1987 Nissan Pulsar nx why does it run badly and not go over 2500 rpms when it gets warm when cold runs great and will rev up?
Have the catalytic converter checked, probably stopped up.
When was the Nissan Pulsar EXA first produced?
The Nissan Pulsar EXA 2-door was produced in 1985. It featured sleek coupe styling with pop-up head lamps. The EXA was known as the NX in North America.
Does the 1989 Nissan Pulsar have a timing chain or a timing belt?
In a 1989 Nissan Pulsar NX : The 1.6 litre four cylinder engine has a timing CHAIN The 1.8 litre four cylinder engine has a timing BELT
Can you modify a Nissan Nx Coupe Car?
Yes.
Where is the thermostat on Nissan Pulsar nx located?
On the 1988 Pulsar NX SE, when you're standing in front of the car, looking into the engine compartment, it's on the left side (the passenger side) near the top of the engine, towards the back. Just follow the big hose from the top of the radiator to where it connects to the engine. It looks like it's held on with 3 bolts that are probably able to be removed using a normal socket set without removing anything major around it. I'm going to replace mine tomorrow...
