answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Where is the temp sender 1996?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Can you swap out an engine from a 1996 Jeep Cherokee 4.0 into a 1991 Jeep Cherokee that has a 4.0?

The 1996 will not have a hole in the rear of the head for the gauges coolant temp sender.


What does a temp sensor sender look like for a 2001 gmc Jimmy?

where it the temp sensor sender located on a 2001 gmc Jimmy


Where is the temperature sender located 1998 ford tarus se?

temp sender located


Where is the temp gauge sender unit fitted on a ford 289?

Temp sender on the 289 should be located at the front of the intake manifold. Source: www.AverageJoeResto.com


What is the difference between the temperature sensor and temperature sender on a 1993 Chevy blazer?

temp sensor - sends signals to the computer for driveability temp sender - measures temp and sends to gauge in dash


Can you tell me the Location of temp sender on f150 six cylinder engine?

can you tell me the location of the coolant temperuture on a 1996 f150 4.9 six cylinder engine


Why my Water temperature gauge doesn't work on 95 explorer?

only 3 reasons a temp gauge wont work the temp sender is bad the gauge is bad or the wire from temp sender to gauge is broken


Why does electric fan not start until red on 1996 n reg 1.4 astra?

this could be a faulty temperature sensor or a faulty fan switch from the temp sender


How to troubleshoot water temp gauge on Chevy lumina gauge reads hot but its the engine is cool?

Take wire off temperature sender look a guage. If guage at cool, temp sender needs replacement. If guage still at hot, temp sender wire shorted to engine or vehicle body.


Why is your temp on 1996 mercury villager always below normal?

Probably one of two reasons: either the sender is bad, or the thermostat is stuck open. Anything else is unlikely.


Why does my temp gauge still not work after changing the sending unit on a 96 ford contour?

Does anybody know the answer to this question??????? YES I HAVE THE ANSWER...REPLACE THE TEMP GUAGE. ITS NOT AS HARD AS YOU WOULD THINK...ABOUT A 20 MIN. JOB ------------------------------------------------ I tried replacing the temp gauge but that wasn't the problem for me. On top of the engine is a temp sender that is all so easy to get to but it is for the engine computer. The temp sender for the gauge is under the water pump. My temp sender went bad because the water pump started leaking. It is like the engine is headed for a major problem of over heating but it disables the temp sender which warns the driver of over heating. It is not easy to change the temp sender but it is doable if you pull off the thermostat housing. Don't put the old thermostat back in. Also, don't get an aftermarket temp sender, I got one and it reads 3/4 hot all the time. It only cost me $5 but I wish I had have bought from the dealer what ever it cost.


What is OBD ll code 128?

the coolant temp is below the regulated temperature.. replace the thermostat and temp sender switch