answersLogoWhite

0


Best Answer

On a 2.5L 1994 YJ, we found the temp sending unit in a tapping at the rear of the cylinder head, in the lower corner toward the exhaust side. The replacement head was not tapped at that location, and we didn't discover that fact until after the head was installed. Does anyone know of an alternate location?

User Avatar

Wiki User

โˆ™ 2006-09-04 20:57:36
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the temperature sending on a 1987 Jeep 2.5L engine block?
Write your answer...
Submit
Sign up for more answers

Registered users can ask questions, leave comments, and earn points for submitting new answers.

Already have an account? Log in

Related questions

Where is the oil pressure sending unit on a 1987 camaro v8 engine?

It is right behind the distributor, screewed into the top of the block.


Where is the oil sending unit on a 1987 Chevrolet Celebrity or the oil pressure switch?

If your Celebrity has the 2.5L 4 cylinder engine the oil sending unit is on the side of the block below the intake manifold. If your Celebrity has the 2.8L V6 the oil sending unit is on the lower side of the block next to the oil filter.


What year is your engine block?

1987 1994


Where is the oil sending unit on a 1987 ford ranger xlt 2.9 v6?

You can find the 1987 four Ranger 2.9 liter engine oil sending unit on the left-hand side of the engine. The oil sending unit will be near the oil filter.


What engine came in a 1987 1 ton Chevrolet?

They had the 350 small block and 454 big block in them.


Where is the fan switch on a 1987 Toyota tercel?

On the back of the engine block.


Where is temperature sending unit on 1987 jeep 4.0 liter Comanche?

If you are standing in front the truck, looking at the engine, the sensor is located near the right, rear corner of the valve cover.


Where is the temperature sending unit on a 1987 Nissan truck?

below top end of radiator hose.


What is a ECT on a 1987 ford?

"Engine Coolant Temperature" sensor.


Where is the oil sending unit on a 1987 Nissan truck engine located?

above oil filter.


Where is the oil sending unit located on 1987 4.3 Chevrolet pickup?

It is in the back of the engine near the distributor


What is the normal engine operating temperature for a 1987 mustang gt?

The normal engine operating temperature for a 1987 Mustang GT is around 200 degrees Fahrenheit. Anything above 220 degrees Fahrenheit might cause the engine to overheat.


Where is the expansion plug located on a 1987 Chevy Jimmy?

There are multiple expansion plugs in the engine block.


Will a Chevy 350 engine fit into a 1987 Buick Regal?

Yes a chevrolet 350 small block will fit in a 1987 Buick Regal.


Is there a conversion kit for Swapping a Small Block Ford engine to a 1987 Fiero GT?

No, because the small block Chev fits so well


Where is the drain plug on the engine block for a 1987 suzuki samuria located?

Bottom of Oil Pan.Cheers Joseph


What was the stock horsepower of a 1987 Mercury RX7 Cougar 5.0L Engine?

about 300 at the block about 220 at the wheels


Where is the horn on a 1987 Honda prelude?

The horn on a 1987 Honda Prelude is located behind the front bumper of the vehicle. It is mounted in front of the engine block.


Where is the coolant temperature sending unit on a 1987 Mazda B2000?

The temperature sender is at located at the thermostat housing.It will have a a singel terminal electrical connector that slides onto the sender.It is directly below the thermostat (note it is where the upper radiater hose goes to the block).Simple autozone or advance auto parts carry this item.


What should a 1987 corvette engine run for temperature before fan kicks in At what temperature is the motor in danger of overheating?

225 degrees


Where is the knock sensor on a 1987 Chevy Suburban 5.7 engine?

Passenger side of block just above the starter


Where is the oil pump on 1987 ford escort 1.9L?

Bottom of engine block located inside the oil pan.


What is the difference between an 1987 and a 1988 Chevy 350 engine block?

There is no difference what so ever. Same engines.


1987 Buick V 6 engine 3.7 liter oil sending unit location?

Just above the oil filter


Oil pressure switch location on a 1987 Nissan 300Z?

Answer It's on the block on the right side of the motor (on the left if you are standing in front of the car looking at the engine). It's almost always easiest to remove the starter to replace it as there isn't much working room....Also if you have a turbo Z there is also another oil switch located on the oil pan which is the oil temperature sending unit......