its screwed in on the front of the water pump
Ground the wire that goes to the temperature sending unit and if the gauge goes up then the sending unit is defective.
The 1994 Chevrolet Astro V-6 engine temperature sending unit can be located on the front of the engine. The temperature sending unit will be next to the thermostat housing.
The fuel sending unit is located inside of the gas tank.
The 1997 Chevrolet Camaro 3.8 liter engine coolant temperature sending unit can be found on the front of the engine. The coolant temperature sending unit will be approximately 3 inches above the thermostat housing.
It is in the driverside head between the first 2 spark plugs.
The temperature sending unit on a 1991 Chevy Caprice with a 305 motor is typically located near the thermostat housing. It is usually screwed into the intake manifold or the engine block, often on the driver's side. To access it, you may need to remove any obstructing components, such as the air intake or other hoses, for better visibility and access.
it is inside the engine where it is supposed to be.. did you think it was in the garage.. go back to school and study math and learn the cosmetics of engines and you'll soon learn where it is.
It's located in the thermostst housing just below the thermostat which is tucked under the Throttlebody!
It may be your flowter in the gas tank. Check the fuel sending for power and ground.
It is on the drivers side head.
The fuel sending unit for the fuel gauge would be located in the fuel tank.
The oil pressure sending switch on a 1988 Chevrolet Celebrity with 2.8L V6 is located on the bottom of the block near the oil filter.